-
FrameTransfer
FRAME地固系和惯性系坐标转换（极移、岁差、章动、参考历元）(FRAME orbit transfer)
- 2014-08-13 14:34:47下载
- 积分：1
-
pso-with-limitation
带有速度限制和种群限制的粒子群优化算法程序。matlab编写。(Populations with speed limits and restrictions on particle swarm optimization algorithm. matlab prepared.)
- 2013-07-24 04:10:46下载
- 积分：1
-
FARIMA-code-and-papers
基于FARIMA的网络自相似业务流模型的研究与仿真
包含三个函数：av.m、far.m、zsrs.m。具体说明见论文及模型说明(Research and simulation of self-similar traffic model based on a FARIMA the network consists of three functions: av.m far.m, zsrs.m. Specific instructions, see papers and model description)
- 2021-01-14 20:58:47下载
- 积分：1
-
fig8b
This paper presents a method to operate a grid
connected hybrid system. The hybrid system composed of a Photovoltaic
(PV) array and a Proton exchange membrane fuel cell
(PEMFC) is considered. The PV array normally uses a maximum
power point tracking (MPPT) technique to continuously deliver
the highest power to the load when variations in irradiation and
temperature occur, which make it become an uncontrollable
source. In coordination with PEMFC, the hybrid system output
power becomes controllable. Two operation modes, the unit-power
control (UPC) mode and the feeder-flow control (FFC) mode, can
be applied to the hybrid system. The coordination of two control
modes, the coordination of the PV array and the PEMFC in the
hybrid system, and the determination of reference parameters
are presented
- 2020-12-21 16:29:09下载
- 积分：1
-
三电平SVG，dq控制策略
说明： 三电平SVG仿真模型，运行于simulink环境下，采用dq控制策略(Three-level SVG simulation model, running in simulink environment, using dq control strategy)
- 2020-06-22 01:00:01下载
- 积分：1
-
DFT
离散傅里叶变换的程序，可以画出原图和频谱(Discrete Fourier Transform process)
- 2009-05-24 13:51:50下载
- 积分：1
-
GM(1-1)
用MATLAB的灰色预测GM（1，1）模型
(Grey with a MATLAB-GM (1,1) model)
- 2011-05-14 21:45:51下载
- 积分：1
-
convmenu
这是关于卷积编码的程序，希望对大家有所帮助．(This is on the coding process, we hope to help.)
- 2006-11-19 16:10:58下载
- 积分：1
-
Car-like-mobile-robot
车式移动机器人圆形轨迹跟踪控制程序，是利用MATLAB做的，还有控制图(Round the car-type mobile robot trajectory tracking control procedures)
- 2020-12-04 11:29:23下载
- 积分：1
-
Audio-denoising-deepa
1. Extract files and run Audio_denoise_main.m file folder...
2. Click on Load & play Audio file and Original sound.wav file
3. Then using slider AWGN (White gauusion noise)...it is vary 1 to 10 set it to 10..
4. now click on Add Noise and play...
5. u can save noisy signal by save noisy signal tab...
6. now wavelet...
7. thresholding..
8. now click on Denoise and play....wait for some time...this will take 25 sec time
9. now save that denoised signal...and record all output parameters...
10. now click on clear all and exit
- 2015-04-18 14:39:47下载
- 积分：1
