登录
首页 » matlab » test

test

于 2013-09-17 发布 文件大小:1KB
0 137
下载积分: 1 下载次数: 4

代码说明:

  已采集线性震动系统(钢板)的输入与输出(时域幅值),求解系统数值解,幅频特征,并作图比较。(Have been collected linear vibration system (steel) input and output (time domain amplitude), numerical solution for solving the system, the amplitude-frequency characteristics, and mapping to compare.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • dds
    matlab下实现的DDS发生器,可观察其发生信号的波形,频谱。 运行前请先输入 global theta theta=0 (matlab implementation of the DDS generator, may happen to observe the signal waveform, spectrum. Please enter a pre-operational global theta theta = 0 )
    2009-03-05 09:53:11下载
    积分:1
  • MIMO
    仿真2*2MIMO通信系统ML、ZF、MMSE检测算法性能,给出三种检测算法的误比特率。(Multi-input multi-output (mimo) communication system simulation 2* 2 ML, ZF and MMSE detection algorithm performance, the bit error rate of three detection algorithms is given.)
    2020-11-13 11:59:43下载
    积分:1
  • cic
    CIC(Cascaded Integrator Comb) filter, 即级联积分梳状滤波器, 具有结构简单, 便于处理, 运算速度快等特点(CIC(Cascaded Integrator Comb) filter)
    2018-06-12 10:14:14下载
    积分:1
  • flc1
    Fuzzy logic controller fis file for my earlier IPMSM files requiring flc1.
    2009-11-17 08:23:56下载
    积分:1
  • phasor
    PLOTTING PHASOR QUANTITIES USING MATLAB IN PSCAD A simple case which uses MATLAB for ploting phasor quantities. Apply the fault during simulation run and observe phasor quantities (you can change type of fault) WARNING * This case only works if you use the Compaq/Intel Fortran Compiler. (PLOTTING PHASOR QUANTITIES USING MATLAB IN PSCAD A simple case which uses MATLAB for ploting phasor quantities. Apply the fault during simulation run and observe phasor quantities (you can change type of fault) WARNING * This case only works if you use the Compaq/Intel Fortran Compiler. )
    2014-01-04 09:44:02下载
    积分:1
  • UKFPFUPF
    upf滤波算法程序,利用MATLAB编写,相当好用(upf filtering algorithm procedure, and use MATLAB to prepare, very easy to use)
    2010-01-02 18:52:38下载
    积分:1
  • am-dsb
    AM、DSB 调制及解调 用matlab产生一个频率为1Hz,功率为1的余弦信源m(t),设载波频率ωc =10 Hz, m0 = 2 ,试画出: 􀁺 AM 及DSB 调制信号的时域波形; 􀁺 采用相干解调后的 AM 及DSB 信号波形; 􀁺 AM 及DSB 已调信号的功率谱; 􀁺 调整载波频率及 m0,观察分的AM 的过调与DSB 反相点现象。 􀁺 在接收端带通后加上窄带高斯噪声,单边功率谱密度0 n = 0.1,重新解调。 (AM, DSB modulation and demodulation Matlab produce a frequency for 1 Hz, power of 1 cosine source m (t), set the carrier frequency ω c = 10 Hz, M0 = 2, try drawing out: )
    2012-03-30 15:29:29下载
    积分:1
  • Mathematical-modeling
    数学建模:最短距离和模拟退火 已调试好(The shortest distance and simulated annealing)
    2011-12-03 13:23:50下载
    积分:1
  • 驾驶员模型数据处理
    驾驶员模型数据处理,论文第二章仿真程序,发表sci(Pilot model data processing, paper chapter ii simulation program, published sci)
    2015-04-21 15:08:40下载
    积分:1
  • gsc1
    generalized sidelobe cancellation implented frome "Adaptive filter theory 3th edition, page 320-335" author: ب ه م ن ی ا ن د ا ن ش گ ا ه ش ی ر ا ز
    2013-07-17 13:02:03下载
    积分:1
  • 696518资源总数
  • 105669会员总数
  • 9今日下载