-
matlabacaculat
数值计算，关于MAtlaB的数值计算方面的程序，希望能帮助大家学习，改进( lyapunove package for solving stochastic differential equations in MATLAB-Solution of stochastic differential )
- 2010-08-25 17:58:03下载
- 积分：1
-
matlabGPS
matlab仿真，关于gps的，一些代码(failed to translate)
- 2013-05-04 20:08:33下载
- 积分：1
-
Hw2
Matrix multiplication for two input matrices
- 2014-01-27 03:10:47下载
- 积分：1
-
event_dip
This code is about synthetics seismic data.
- 2009-11-13 03:25:51下载
- 积分：1
-
simulatorgrid
电网模拟器，用来模拟电网的各种故障，用来检测并网逆变器的性能。(the gridsimulator use back to back PWM simulator realise the grid )
- 2016-09-07 16:16:07下载
- 积分：1
-
sw_dist
本程序用来计算matlab中两点坐标之间的距离，坐标必须是经纬度，并表明所要计算的单位(This procedure used to calculate the matlab in the distance between two coordinates, latitude and longitude coordinates must be, and show that to calculate the unit)
- 2021-05-12 21:30:03下载
- 积分：1
-
Calibration.tar
这是IMU标定的中文文档,详细说明了加速度计和陀螺仪的标定(This is the Chinese IMU calibration documentation detailing the accelerometer and gyroscope calibration)
- 2021-05-06 17:22:07下载
- 积分：1
-
kalman
基于卡尔曼滤波器的交通流量分析系统，输入方式采用.txt文件形式(Kalman filter based on the traffic analysis system)
- 2009-02-02 22:13:41下载
- 积分：1
-
MATLAB_programming_source_filtering_algorithm_for_
MATLAB程序设计数值微分滤波算法设计源码MATLAB programming source filtering algorithm for numerical differentiation(MATLAB programming filtering algorithm for numerical differential source MATLAB programming source filtering algorithm for numerical differentiation)
- 2010-08-02 12:42:27下载
- 积分：1
-
GND
接地技术最早是应用在强电系统（电力系统、输变电设备、电气设备）中，为了设备和人身的安全，将接地线直接接在大地上。由于大地的电容非常大，一般情况下可以将大地的电位视为零电位。后来，接地技术延伸应用到弱电系统中。对于电力电子设备将接地线直接接在大地上或者接在一个作为参考电位的导体上，当电流通过该参考电位时，不应产生电压降。然而由于不合理的接地，反而会引入了电磁干扰，比如共地线干扰、地环路干扰等，从而导致电力电子设备工作不正常。可见，接地技术是电力电子设备电磁兼容技术的重要内容之一，有必要对接地技术进行详细探讨。(Grounding technology was first applied in strong electric system (power system, power transmission equipment, electrical equipment), in order to equipment and personal safety, the ground wire directly connected to the earth. Because the earth capacitance is very large, under normal circumstances can be considered to be zero potential earth potential. Later, grounding techniques applied to extend the weak system. For power electronic devices directly connected to the ground wire on the ground or connected to a reference potential as a conductor, when the current through the reference potential, and should not generate voltage drop. However, due to unreasonable ground, but will the introduction of electromagnetic interference, such as co-ground interference, ground loop interference, resulting in power electronic equipment is not working properly. Visible, grounding technology is an important part of power electronic equipment EMC technology, it is necessary for grounding techniques disc)
- 2015-02-07 09:58:04下载
- 积分：1
