-
cyclic_cross_correlation
说明： 循环平稳时间序列的循环互相关的matlab程序(Cyclostationary time-series of the cycle of inter-related procedures matlab)
- 2008-10-03 20:48:50下载
- 积分：1
-
iir_flp32
TigerSharc TS201 32-bit floating point IIR filter routine.
(TigerSharc TS-201 32-bit floating point II R filter routine.)
- 2006-11-06 22:41:35下载
- 积分：1
-
Time-frequency-
时频分析技术及其应用——随书光盘源码.rar(Time frequency analysis technology and Its Application-- source CD with the book)
- 2012-05-03 19:08:35下载
- 积分：1
-
code
code for calculating zernike moments
- 2012-05-08 15:20:42下载
- 积分：1
-
Training_TUM_GS_Simulink
Training matlab simulink
- 2014-09-03 23:37:17下载
- 积分：1
-
matlab
在采样点之间的频率响应是由各采样点的加权内插函数叠加而形成的，因而有一定的逼近误差。该误差大小取决于理想频率响应的形状，理想频响特性变化越平缓，内插值越接近理想值，逼近误差越小；反之，如果采样点之间的理想频响特性变化越陡，则内插值与理想值之间的误差越大，因而在理想滤波器不连续点的两边，就会产生尖峰，而在通带和阻带就会产生波纹。用频率采样法设计的实际滤波器频率响应如图1所示。由图1可知，实际滤波器的阻带衰减取决于内插函数第一旁瓣幅度值的大小，其大小决定了所设计的滤波器的阻带性能。(Interpolation function superimposed between sampling points of the frequency response is weighted within each sampling point and the formation of, and thus have a certain degree of approximation error. The size of this error depends on the shape of the ideal frequency response and the ideal frequency response characteristic change is more gentle, interpolated and more close to the ideal value, the smaller the approximation errors Conversely, if the sampling point between the ideal frequency response characteristics of the steeper the change, and then the interpolated the larger the error between the ideal value, and thus in the ideal filter both sides of the discontinuity point, will produce spikes occurs ripple in the passband and stopband. Actual design frequency sampling filter frequency response is shown in Figure 1. Figure 1 shows, the actual filter stopband attenuation depending on the interpolation value of the size of the first side-lobe amplitude of the function that determin)
- 2013-03-12 13:47:15下载
- 积分：1
-
yewn78.3
This paper presents a new and efficient approach for capacitor placement in
radial distribution systems (RDS) that determine the optimal locations and size of
capacitor with an objective of improving the voltage profile and reduction of power loss.
The solution methodology has two parts: in part one the loss sensitivity factors (LSF) are
used to select the candidate locations for the capacitor placement and in part two a new
algorithm that employs Dijkstra Algorithm (DA) is used to estimate the optimal size of
capacitors at the optimal buses determined in part one. The main advantage of the
proposed method is that it does not require any external control parameters. The other
advantage is that it handles the objective function and the constraints separately. The
proposed method is applied to 33 & 69 RDS. The solutions obtained by the proposed
method are compared with other methods. The proposed method has outperformed the
other methods in terms of the quality of solution.
OPTIMAL C
- 2013-12-16 14:27:18下载
- 积分：1
-
S_函数的PWM仿真_
基于s函数的spw仿真程序简单易懂便于操作(SPW simulation based on s function)
- 2021-04-22 23:38:48下载
- 积分：1
-
3
说明： matlab 科学计算与可视化程序集。几百个小程序供初学者掌握matlab的科学计算十分有帮助。(matlab scientific computing and visualization of the assembly. Hundreds of small programs for beginners to master the scientific computing matlab very helpful.)
- 2009-12-16 14:06:45下载
- 积分：1
-
Modalparameteridentification
应用经典prony法和AR参数建模进行模态参数识别(Prony method and the application of the classical AR modeling parameters for modal parameter identification)
- 2007-07-31 15:00:55下载
- 积分：1
