-
shiyu
绘出时域图，在时域上进行分析，提取时域特征值：绝对均值，标准差，有效值，方根幅值，波形指标等等，进行故障特征提取，识别故障(The time domain diagram is drawn and the time domain is analyzed. The time domain eigenvalues are extracted: absolute mean, standard deviation, effective value, square root amplitude, waveform index and so on. Fault feature extraction and fault identification are carried out.)
- 2018-06-01 21:19:27下载
- 积分：1
-
SSA_1
一个关于混沌序列的噪声压缩程序，主要基于主分量分析方法，消噪效果非常好。模拟信号上加了100 ％噪声(a chaotic sequence of the noise compression procedures, mainly based on principal component analysis, denoising very good results. Analog signals on the 100% increase in noise)
- 2006-07-10 16:54:18下载
- 积分：1
-
ForWaRD
(ForWaRD)Fourier-Wavelet Regularized Deconvolution的完整MATLAB代码，内包括相应文献，该方法用去复原图像，去模糊。((ForWaRD) Fourier-Wavelet Regularized Deconvolution of the complete MATLAB code, which includes the corresponding literature, the method used up recovery images, go fuzzy.)
- 2010-08-22 18:27:44下载
- 积分：1
-
mianyichengxu
基于免疫网络模型的免疫算法源程序，MATLAB编程，仅供大家参考(based on the immune network model immune algorithm source code and MATLAB programming, is for your reference)
- 2007-04-14 10:48:46下载
- 积分：1
-
SystemIdentifycationandMATLAB
说明： 系统辨识与MATLAB仿真程序，是学习系统辨识很好的参考资料和参考程序(MATLAB system identification and simulation program, is a good reference for learning system identification and reference procedures)
- 2010-04-29 09:28:26下载
- 积分：1
-
MATLAB-
这里面有MATLAB常用的一些算法，用于计算数值计算，文件格式为.m(There MATLAB commonly used in some algorithms used to calculate the numerical calculation for the file format. M)
- 2012-06-09 17:39:21下载
- 积分：1
-
FH
说明： 跳频系统的同步simulink仿真（R2010b）(Synchronous hopping simulink simulation system)
- 2014-03-25 12:06:19下载
- 积分：1
-
Surface
利用最速下降法计算最小曲面的面积，初始条件为0，边界条件为正方形固定边界。(Using steepest descent method to calculate the minimum surface area. Initial condition is 0, while boundary condition is square fixed values.)
- 2015-02-05 18:36:12下载
- 积分：1
-
57991
ADP算法最原始的代码，适用于2012年自适应动态规划论文(2012 JZP paper Adaptive Dynamic Programing by Counting linear system)
- 2021-01-19 18:38:42下载
- 积分：1
-
Viterbi
详细的卷积编码与维特比译码算法。产生随机信号，对信号进行卷积编码，然后经过数值转换、格雷编码，QPSK调制，进入加噪信道，之后进行QPSK解调，格雷解码， 数制转换、 维特比译码得到接收端的信号。(Detailed convolutional coding and Viterbi decoding algorithm. Random signal, the signal convolution coding, and then through numeric conversion, Gray coding, QPSK modulation, plus noise into the channel, followed by QPSK demodulation, decoding Gray, number system conversion, Viterbi decoding to get the receiving end of the signal.)
- 2014-01-01 12:41:26下载
- 积分：1
