-
ComQueue
labview中对串口进行操作，注意：这不是普通的操作方法，而是使用队列的方法，避免了数据乱串的象限。(labview visa queue control)
- 2020-10-12 22:47:32下载
- 积分：1
-
采集系统最终版
labview编写采集数据程序，数据采集后会有相应的频谱分析(LabVIEW writing data acquisition program)
- 2020-11-24 18:19:33下载
- 积分：1
-
6.1 图形显示控件
分享下labview图形显示控件，非常好用的呀(Share the labview graphical display control, very easy to use, suitable for LabVIEW beginners)
- 2018-07-24 09:17:29下载
- 积分：1
-
拉力传感器电机控制
说明： 数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)
- 2020-06-17 02:00:01下载
- 积分：1
-
sndExample-adv
Labview基于声卡的频谱分析
声卡采集声音数据,显示其波形,通过滤波器和加窗处理进行功率谱分析(Labview based sound card spectrum analysis
Sound card data collection, display its waveform, through the filter and window processing power spectrum analysis)
- 2017-01-10 10:26:25下载
- 积分：1
-
PC-in-Labbview
用labview实现振动信号采集,用于机械故障诊断，路形检测等(Realize vibration signal acquisition with labview for mechanical fault diagnosis, road shape detection)
- 2014-02-18 13:05:30下载
- 积分：1
-
4-2
使用For循环产生100个0~1之间的随机数，并同时判定当前随机数的最大值和最小值(For loop to generate 100 random numbers between 0 and 1, and at the same time to determine the minimum and maximum values of the current random number)
- 2020-10-03 16:57:41下载
- 积分：1
-
USB-RAW---Bulk-ch341
labview中usb raw设备的读取和写入程序 非常有用(labview usb raw device in the read and write process is very useful)
- 2021-04-25 10:58:46下载
- 积分：1
-
ttt
在LabVIEW中实现数据信号的采集与简单分析，在图形化的界面中显示出来(In LabVIEW the data collection and simple analysis of the signal, in the graphical interface shown)
- 2010-03-04 17:29:39下载
- 积分：1
-
FFTfrequency
基于labview测正弦信号频率，使用FFT的算法，然后进行波峰检测(Based labview measured frequency)
- 2013-01-08 15:15:52下载
- 积分：1
