登录
首页 » Asm » ee9346

ee9346

于 2013-10-30 发布 文件大小:5KB
0 172
下载积分: 1 下载次数: 1

代码说明:

  pic 9348 读写测试877芯片上通过测试(pic 9348 literacy test)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • LCD1602
    1602LCD工作于四位模式实时显示当前时间,本程序液晶数据端口仅使用了四只引脚,实现日期时间的实时显示.(1602LCD works in four modes display the current time, the program uses only the LCD data port four pins, date and time of the real-time display.)
    2013-09-08 20:28:00下载
    积分:1
  • PS2keypanel
    单片机键盘接口,可以用于单片机使用键盘,省去很多时间(PS/2 jian pan jie kou cheng xu )
    2010-05-26 11:16:21下载
    积分:1
  • LLC控制程序-闭环-50kHz
    实现LLC的闭环控制程序,低频情况,高输入电压(Closed loop control of LLC)
    2021-02-03 10:49:59下载
    积分:1
  • ps32
    PS32自动气象站的嵌入式代码,stm32主控,包裹GPRS模块M33G和AD7792,ublox电子罗盘,GPS等驱动。C代码(PS32 AWS embedded code, stm32 master, wrapped GPRS module M33G and AD7792, ublox electronic compass, GPS and other drivers. C code)
    2014-01-23 14:52:13下载
    积分:1
  • 最终版跷跷板
    本实验开机后,先初始化MPU6050,然后利用DMP库,初始化MPU6050及使能DMP,最后,在死循环里面不停 读取:温度传感器、加速度传感器、陀螺仪、DMP姿态解算后的欧拉角等数据,通过串口上报给上位机(温 度不上报),利用上位机软件(ANO_Tech匿名四轴上位机_V2.6.exe),可以实时显示MPU6050的传感器状 态曲线,并显示3D姿态,可以通过KEY0按键开启/关闭数据上传功能。同时,在LCD模块上面显示温度和欧拉 角等信息。DS0来指示程序正在运行。另外,本例程也可以通过USMART调用MPU_Read_Byte/MPU_Write_Byte 等函数,来实现对MPU6050寄存器的读写操作(仅在UPLOAD OFF状态下).(This experiment starts with initializing MPU6050, then using DMP library, initializing MPU6050 and enabling DMP. Finally, it keeps on in the dead cycle. Read: temperature sensor, accelerometer, gyroscope, Euler angle after attitude calculation of DMP and other data, report to PC through serial port (temperature). The sensor of MPU6050 can be displayed in real time by using the upper computer software (ANO_Tech anonymous four-axis upper computer_V2.6.exe). The state curve and 3D posture can be displayed, and the data upload function can be turned on/off by KEY0 button. At the same time, temperature and Euler are displayed on the LCD module. Angle and other information. DS0 to indicate that the program is running. In addition, this routine can also call MPU_Read_Byte/MPU_Write_Byte through USMART Equivalent function to achieve the read-write operation of MPU6050 registers (only in UPLOAD OFF state).)
    2020-06-24 18:40:02下载
    积分:1
  • 时钟
    说明:  此代码为在proteus中仿真代码,实现功能:利用液晶显示时间,通过按键调节时分秒。(This code is a simulation code in proteus. It realizes the function of adjusting the time and seconds by keystrokes using liquid crystal display time.)
    2019-01-01 10:42:37下载
    积分:1
  • SD-RW
    基于51单片机的SD卡读写程序,写的很好的. (51 Based on the SD card reader Singlechip procedures, written in very good.)
    2009-01-29 15:13:11下载
    积分:1
  • STM32_KS103_IIC
    0.我使用的是F103VET6,但软件IIC原理都是一样的,改引脚配置后可方便移植 1.连接引脚前,可以只连接VCC和GND查看模块当前地址:模块上的LED指示灯会渐亮,然后就是快闪(1)和慢闪(0),将值记录下来,用计算器转换一下就是当前的地址值了(0. I use F103VET6, but the principle of software IIC is the same, pin configuration can be easily transplanted. 1. Before connecting pins, you can only connect VCC and GND to view the current address of the module: the LED light on the module will gradually light up, then flash (1) and slow flash (0), record the value, and convert it with a calculator to the current address value.)
    2020-06-19 11:20:02下载
    积分:1
  • RX2
    small RTOS 嵌入式实时多任务开发,无线发送程序(small RTOS for embedded real-time multi-task development, wireless Send procedures)
    2006-05-29 22:21:06下载
    积分:1
  • pdf2
    cfd simulation for heat transfer and mass transfer problems
    2009-03-21 17:02:32下载
    积分:1
  • 696516资源总数
  • 106783会员总数
  • 25今日下载