-
DFE_4QAM
在无线通信中，存在着严重的多径现象，能够引起严重的ISI。判决反馈均衡器（DFE）是目前最常用的一种消除ISI的均衡器。本程序使用Matlab实现的QPSK下的DFE。(In wireless communication, there is a serious multi-path phenomenon, can cause severe ISI. Decision feedback equalizer (DFE) is the most commonly used in an equalizer to eliminate the ISI. This procedure using Matlab under QPSK realize the DFE.)
- 2021-03-27 21:49:12下载
- 积分：1
-
jEKF
一个关于卫星导航方面的ekf滤波程序，请大家互相共享一下(a satellite navigation on the ekf filtering process, please share what each other)
- 2007-04-22 12:08:12下载
- 积分：1
-
sound
包含了使用matlab对声音信号进行时域和频域分析，加高斯噪声，并用高通、低通、带通滤波器进行滤波，并显示波形图。(Contains the sound signal using matlab time domain and frequency domain analysis, plus Gaussian noise, and high-pass, low pass, band pass filter to filter and display waveforms.)
- 2011-07-20 15:19:58下载
- 积分：1
-
Learning-Programming-Using-MATLAB
Sayood K. Learning Programming Using MATLAB
- 2014-08-27 01:10:46下载
- 积分：1
-
jam_fm
说明： 噪声调频干扰信号的matlab仿真实现，其中包含成像的提取程序(SAR jamming of noise moding frequency)
- 2019-04-18 23:23:59下载
- 积分：1
-
MATLAB6.0mathtical
这个是在matlab环境下的一个数学手册，详细讲解了在matlab下是怎么样对一个数据的表示和操作。(This is in the on the a mathematical under the the Manual in in the matlab environment, explain in detail the the under in the matlab is the how-like on the the the the of the said that and operation of of the a data-.)
- 2013-03-29 11:32:55下载
- 积分：1
-
cwts-specs-013-RRC331
IMT-DS FDD(WCDMA)系统无线接口层3技术规范：
无线资源控制协议(RRC)
IMT-DS FDD(WCDMA) System Radio Interface Layer3 Technical Specificaiton: RRC Protocol
(IMT-DS FDD (WCDMA) system, radio interface layer 3 specification: radio resource control protocol (RRC) IMT-DS FDD (WCDMA) System Radio Interface Layer3 Technical Specificaiton: RRC Protocol)
- 2010-12-09 10:00:13下载
- 积分：1
-
ImageEditor
说明： Image Editor, using matlab and guide
- 2015-02-12 04:49:40下载
- 积分：1
-
(STM32)ADC DMA USART(仅必须的C文件不含工程)
说明： simulink控制系统模拟,关于信号的采集(simulation of simulink's control)
- 2017-09-28 20:40:21下载
- 积分：1
-
BatchSimulation
As we know, the energy needed for sensors should be electrical. So the rst
step before start to work is to convert environmental energy to electrical one.
Inside the node there are dierent components for sensing the area, collecting
data and processing the data. So the main dierent part of this kind of nodes,
in compare of WSN nodes, is the power part. Once the stored energy reach
to a certain amount, the power supply for micro controller and transceiver will
start to work. They will continue to work until they have energy, as soon as the
energy nish, they stops and energy storage device start to work to save energy
again.
The other fact should be consider about EH-WSN node is that the available
energy can change in dierent nodes. So every node has its own harvesting rate.
- 2013-07-20 14:34:56下载
- 积分：1
