-
MATLAB_help
matlab中文帮助文档，文档为HTML帮助文档格式。通过中文简要介绍了MATLAB的使用方法。(Chinese matlab help document, document, document formats HTML Help. By Chinese brief introduction to the use of MATLAB.)
- 2013-01-14 00:34:45下载
- 积分：1
-
ziranfeng1
应用simulink搭建的一个自然风仿真模型，系统中实用了Matlab Fcn 。(Practical application simulink to build a natural wind simulation model system Matlab Fcn.)
- 2012-09-06 21:38:41下载
- 积分：1
-
zhengfang-XY
声子晶体的源程序：圆柱形散射体呈正方形排列的ＸＹ模的程序(Phononic crystal source: cylindrical scattering takes the shape of a square arrangement of the XY model program)
- 2021-04-20 14:58:50下载
- 积分：1
-
MT-RFSG-Generate-PSK
生成PSK信号。并基于NI的软件无线电平台发送射频信号(PSK signal is generated. And software radio platform based on NI RF signal sent)
- 2014-01-20 11:39:23下载
- 积分：1
-
zonghexunlian1
实际光源不是绝对的单色，包含一定的光谱宽度△λ。△λ范围内的每一种波长的光都生成各自一组干涉条纹，除零干涉级外，相互间均有位移，使条纹对比度下降。(The actual light source is not absolutely monochromatic, contain a certain spectral width △ λ. Each wavelength of light within the range △ λ generates a set of interference fringes each, in addition to the zero level outside interference, mutual displacement are so fringe contrast decreases.)
- 2015-01-10 18:36:54下载
- 积分：1
-
TravelSalesmanProblemWithGA
Solving Travel Salesman Problem with Genetic Algorithm
- 2013-03-16 00:32:02下载
- 积分：1
-
Chap4-Forces
Chapter 4 - Forces and Moments
- 2015-03-03 09:10:13下载
- 积分：1
-
IEEE_UWB_recommend_matlab-simulation
该压缩包包括两个m文件，一个为IEEE推荐的UWB信道模型的matlab仿真程序，另一个为对应的RMS时延扩展计算，并附带了一个文档文件作说明。(The archive includes two m files, one for the IEEE UWB channel model recommended by the matlab simulation program, and the other for the corresponding calculation of RMS delay spread, and comes with a document file for instructions.)
- 2010-05-19 20:45:25下载
- 积分：1
-
post-phase-correction
matlab与VPI联合仿真，QAM 相位纠正程序(matlab QAM)
- 2012-04-18 16:06:59下载
- 积分：1
-
bottom_up_segmentation
这是TD算法的逆过程，首先将时间序列，划分为相邻点的短序列，当然此时的拟合误差为0，因为第一点和第二点的连线，原始点都落在线段上。将相邻两个线段连接起来，此时每条线段包含三个原始点，计算中间那个点的拟合误差。这样，所有这些三个点的线段中的中间点的拟合误差计算出来后，找出误差最小且误差小于阀值R的分段，作为第一条包含三个点的线段。 在上面的基础上，第一条分段同样的和相邻线段连接，然后计算每一条分段的拟合误差，再找出误差最小且小于阀值R的分段，作为第二个分段。依次方式循环，直到所有分段的拟合误差都小于阀值R，分段结束。
(This is the reverse process of TD algorithm, the first time series is divided into short sequences adjacent dots, of course fitting error is zero at this time, because the first and second points of connection, the original point fall line on. The two adjacent segments are connected, then each segment contains three original point, the intermediate fitting error calculated that point. Thus, after all these segments fitting error of three points in the intermediate point calculated to find the minimum error and the error is less than the threshold R segment, as the first line contains three points. Based on the above, the first segment and the adjacent line segment connecting the same, and then calculate a fitting error for each segment, and then find the smallest error and less than the threshold R segment, as the second segment . Followed by a cyclic manner until all segments fitting error is less than the threshold R, segment ends.)
- 2021-03-20 16:29:18下载
- 积分：1
