登录
首页 » matlab » RLE

RLE

于 2012-09-13 发布 文件大小:1KB
0 150
下载积分: 1 下载次数: 4

代码说明:

  Run-length encoding (RLE) is a very simple form of data compression in which runs of data (that is, sequences in which the same data value occurs in many consecutive data elements) are stored as a single data value and count, rather than as the original run.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • PSO-Fuzzy-Modeler-Mamdani-for-charger
    PSO Fuzzy Modeler (Mamdani) for charger
    2013-12-09 08:01:47下载
    积分:1
  • test_wav
    说明:  使用小波对脑电信号进行分解,去噪,重构 小波‘db1’-‘db10’分别处理对比(Using wavelet to decompose, denoise and reconstruct EEG signal)
    2020-05-27 17:00:03下载
    积分:1
  • CurveFitting
    Chapter 5. Curve Fitting Algorithm 5.1 Least Squares Line Algorithm 5.2 Least Squares Polynomial Algorithm 5.3 Non-linear Curve Fitting Algorithm 5.4 Cubic Splines Algorithm 5.5 Trigonometric Polynomials
    2011-06-07 03:09:47下载
    积分:1
  • exam3_1
    结构分析的有限元法与matlab程序设计3-1(Structural analysis of the finite element method and matlab programming 3-1)
    2011-06-09 16:23:00下载
    积分:1
  • dcdcvenki
    A DC/DC Boost Converter was developed using the simulink tool box
    2014-08-14 16:49:28下载
    积分:1
  • elm
    经验似然计算 在非参数统计推断中可以构造似然比, 很有用。(empirical likelihood)
    2015-03-07 21:11:22下载
    积分:1
  • kanglei_v58
    是学习PCA特征提取的很好的学习资料,光纤无线通信系统中传输性能的研究,小波包分析提取振动信号中的特征频率。( Is a good learning materials to learn PCA feature extraction, Fiber Transmission wireless communication system performance, Wavelet packet analysis to extract vibration signal characteristic frequency.)
    2016-05-15 16:59:28下载
    积分:1
  • kmeans
    基于K-means的模糊聚类分析方法,很有用的(Based on the fuzzy K-means cluster analysis, very useful)
    2010-12-11 10:02:37下载
    积分:1
  • Boost_Converter
    说明:  升压转换器是一种DC / DC电源转换器,可将电压从其输入(源)升至其输出(负载)。在连续导通模式下(流经电感的电流永远不会降为零),升压转换器的理论传递函数为: 占空比在哪里0.5 在此示例中,转换器从250 V电源馈送RC负载,并且PWM频率设置为31 kHz。 模拟 运行仿真并观察示波器上的波形。确认负载电压(Vout)的平均值非常接近理论值:Vout = 250 /(1- 0.5)= 500V。(A boost converter is a DC/DC power converter which steps up voltage from its input (source) to its output (load). In continuous conduction mode (current through the inductor never falls to zero), the theoretical transfer function of the boost converter is: where is the duty cycle.0.5 In this example, the converter is feeding an RC load from a 250 V source and the PWM frequency is set to 31 kHz. Simulation Run the simulation and observe waveforms on Scope. Verify that the mean value of the load voltage (Vout) is very close to the theoretical value of: Vout = 250 / (1 - 0.5) = 500 V.)
    2020-03-22 20:41:56下载
    积分:1
  • climatiques
    Changes in ambient temperature and sunlight for a day depending on the time. data the sunshine and temperatures are obtained the application PVGIS
    2014-11-20 20:09:08下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载