-
16QAM
16QAM 调制解调的matlab仿真及误码率的计算。(16QAM modulation and demodulation)
- 2018-04-12 10:45:32下载
- 积分：1
-
1223_d18c879e585bc226263466c6321da618
Software engineering
- 2014-11-23 20:29:23下载
- 积分：1
-
generate2DinputFile
This code is used to create input files for the 2D FEM solver used in
ME 413 course. It uses the freely available mesh2d mesh generator to
create the mesh.
- 2015-01-21 09:18:30下载
- 积分：1
-
jaojou_V4.5
相参脉冲串复调制信号，有详细的注释，关于小波的matlab复合分析。( Complex modulation coherent pulse train signal, There are detailed notes, Matlab wavelet analysis on complex.)
- 2016-09-26 15:07:17下载
- 积分：1
-
steercontroller
主要是通过程序设计，设计简单驾驶员转向控制模型(Mainly through program design, simple design the driver steering control model)
- 2013-03-05 10:26:59下载
- 积分：1
-
fuzzycontrol
基于模糊控制的路边平行停车仿真matlab源代码，对于学习模糊控制理论有帮助。(Parallel parking simulation matlab source code is based on fuzzy control roadside, for learning fuzzy control theory help.)
- 2014-12-21 14:31:38下载
- 积分：1
-
ADRC_simulink
说明： 自抗扰算法仿真程序，算法学习使用，适合理论分析(Auto disturbance rejection algorithm simulation program, algorithm learning and use, suitable for theoretical analysis)
- 2020-04-17 09:29:48下载
- 积分：1
-
Everyday_Practical_Electronics_2010_09.pdf
Everyday Practical Electronics Magazine 2010 september
- 2014-09-06 05:20:25下载
- 积分：1
-
find_peak
从曲线中检测到其峰值：先利用二次求导得到所有凸点，设置门限，去除过低的凸点，然后利用滑动窗的方法，在凸点中求得满足峰值要求的点(Detected from the curve to its peak: the first use of the second derivative method to get all the bumps, set the threshold too low to remove the bumps, and then use a sliding window, obtained in a bump to meet peak requirements of point)
- 2014-02-24 16:32:16下载
- 积分：1
-
用于工业机器人轨迹规划chapter
说明： 用于工业机器人轨迹规划，主要是蚁群算法的matlab实现。(For trajectory planning of industrial robots.)
- 2020-07-19 16:08:47下载
- 积分：1
