登录
首页 » matlab » matlabaanswer

matlabaanswer

于 2013-10-09 发布 文件大小:4784KB
0 122
下载积分: 1 下载次数: 7

代码说明:

  薛定宇《高等应用数学问题MATLAB 求解》习题参考解答,一本学习matlab不错的书(Xue Dingyu " higher MATLAB to solve mathematical problems" exercises reference answers, a good book to learn matlab)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 2013TSP
    通过并行压缩进行二维信号压缩,提出了一种利用并行压缩传感技术对二维信号进行压缩的新方案。根据这个原理,译码器的重新构造可以并行进行。通过对二维信号进行某些排列,可以确保所有列具有大致相同的密度级别,并且可以使用相同的测量矩阵进行采样。这样可以避免二维信号的矢量化,从而大大减小测量矩阵的尺寸。我们证明,如果排列良好,重建均方误差的上限会更紧。为了说明这一方案,我们将其应用于视频压缩并使用不同帧的排列有两种:参考帧的基于Z字形扫描的排列和非参考帧的基于块测试的排列。仿真结果表明,在相同的压缩比下,峰值信噪比比比在无置换情况下可提高3-7db左右。(we propose a new scheme to compress 2D signals using parallel compressed sensing. According to this seheme, the reeonstruction at the decoder can be performed in parallel. By performing certain permutation on a 2D signal, all columns are insured to have approximately the same density level and can be sampled using the same measurement matrix. In this way, vectorization of a 2D signal can be avoided, and thus the size of the measurement matrix can be dramatically reduced. We prove that with a good permutation, we can have a tighter upper bound on reconstruction mean square error. To illustrate this scheme, we apply it to video compression and use two kinds of permutations for different frames: the zigzag-scanbased permutation for reference frames and the block-test-based permutation for non-reference frames. Simulation results show that under the same compression ratio, the peak signal-to-noise ratio can be improved by approximately 3-7 dB compared to the case without permutation.)
    2019-01-12 22:48:49下载
    积分:1
  • multivariable_feedback_control
    this is a book on practical feedback control and not on system theory generally.feedback is used in control systems for two reasons,it use matlab.
    2010-11-10 16:10:37下载
    积分:1
  • sym_correlation_profile
    用于计算复杂网络节点相关性,帮助大家对复杂网络的结构进行分析和计算,从而更加深刻的刻画网路结构。(Complex network nodes correlation)
    2012-04-12 15:50:43下载
    积分:1
  • xyz_116_t
    该文件程序可用于任意螺旋锥齿轮加工参数的齿面数据点的输出,可直接修改参数,得出对应的齿轮齿面,为齿轮的建模和TCA提供一定的基础。(The output of the file that can be used for any machining parameters of spiral bevel gear tooth surface data points, you can directly modify the parameters derived corresponding gear tooth surface, providing a foundation for modeling gear and TCA.)
    2021-03-17 16:39:21下载
    积分:1
  • PCM
    PCM clustering algorithm
    2014-11-25 19:55:08下载
    积分:1
  • cn2d-fig
    Crank nicolson method of numerical methods of integration. Used for all Computational Fluid dynamics applications.
    2013-11-17 05:21:28下载
    积分:1
  • eye
    介绍了用matlab学习眼图的程序,效果还是很不错的。(Describes and learns the eye with matlab , the effect is very good)
    2020-12-02 01:29:26下载
    积分:1
  • CS-reconstruction
    通过各种方法对图像进行稀疏化分解,最后用压缩感知算法进行重建(The image is sparse decomposed by various methods, and finally reconstructed by compressed sensing algorithm)
    2017-09-09 10:04:50下载
    积分:1
  • prg
    system identification matlab codes...
    2011-09-14 14:50:28下载
    积分:1
  • mm1Sp.m
    MM1 code ..please check this out. This is MM1 tandem code that I used recently. May need to modify a bit to your situation. Ok have fun and enjoy!!!!
    2013-03-25 07:12:33下载
    积分:1
  • 696518资源总数
  • 105540会员总数
  • 37今日下载