-
xunhuanbaoshu
这个程序针对的问题是: 17个人为成圈,依次编号为0-16,从第一号开始报数,报到3的倍数的人离开, 一直数下去,直到最后只剩1人,求此人的编号. 程序有点复杂，不过还只能算是初级的水平 (This procedure for the question is: 17 individuals into the circle, followed by numbered 0-16, from the first to begin reported the number of people who report a multiple of three to leave, to keep counting votes until the last only a person seeking this person number. program a bit complicated, but can only be considered the primary level of)
- 2010-01-27 01:17:44下载
- 积分：1
-
lyapunov
说明： 用C-C时间序列插入构造李亚普诺夫计算方法(Time series with CC Insert method of calculating Lyapunov structure)
- 2008-10-07 20:03:56下载
- 积分：1
-
m_file
this is source seperation matlab code
- 2013-09-19 05:39:49下载
- 积分：1
-
MeanShift
Mean shift sementation. matlab
- 2009-02-25 10:48:15下载
- 积分：1
-
Plot This curves Receiver Operating Characteristic (ROC) EER
Plot This curves
Receiver Operating Characteristic (ROC) curve
Detection Error Trade-off (DET) curve
FAR vs FRR
- 2014-10-09 12:32:57下载
- 积分：1
-
fd
说明： 有限差分法数值模拟弹性波动方程，使用matlab编写的。(Finite difference method numerical simulation of elastic wave equation, using matlab prepared.)
- 2011-07-13 15:13:13下载
- 积分：1
-
voice_detection
voice detection
- 2013-03-03 16:17:52下载
- 积分：1
-
kernelPCA
KPCA可以用作数据压缩与提取。是一个很好的函数，可直接调用(KPCACan be used for data compression and extraction. Is a good function, can be called directly)
- 2015-03-12 14:01:54下载
- 积分：1
-
remez_frf
说明： 压缩包中包含两个matlab文件：
remez_frf.m 为使用remez算法设计旁瓣1/f衰减滤波器程序；
myfrf.m 为其中使用到的惩罚函数；
frf的意思是频率响应函数。(Compression matlab package contains two files: remez_frf.m algorithm designed for the use of remez sidelobe 1/f attenuation filter procedures myfrf.m use for which the penalty function frf mean frequency response function.)
- 2009-08-02 21:41:41下载
- 积分：1
-
kd
说明： 根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。
将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation .
Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)
- 2014-11-12 11:06:13下载
- 积分：1
