-
51chuankoutiaoshi
51单片机串口调试程序一列,希望对大家有用(51 Single-chip serial debugging a program, in the hope that useful to everybody)
- 2008-05-20 12:10:22下载
- 积分：1
-
aloha
说明： aloha协议仿真基于omnet仿真平台(aloha agreement omnet simulation based simulation platform)
- 2006-05-16 00:23:46下载
- 积分：1
-
DHT22-2
温度传感器DHT22的检测程序，在1602液晶上显示当前环境温度及湿度，精确度0.1，误差范围为2HR ，0.4C(DHT22 temperature sensor detection program that displays the current ambient temperature and humidity, the accuracy of 0.1, the error range is 2HR , 0.4C in 1602 on LCD)
- 2021-03-06 17:39:30下载
- 积分：1
-
LED-S1234
基于STC89C52单片机实现中断LED数码管显示及处理的程序，适合初学值使用(Based STC89C52 MCU interrupt LED digital display and processing procedures, suitable for beginners to use the value)
- 2013-11-19 11:42:46下载
- 积分：1
-
FreeRTOS实验17-1 FreeRTOS内存管理实验
硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
按下KEY_UP键申请内存，内存申请成功以后就可以使用了，按下KEY0键
就是使用申请到的内存。当内存使用完成以后就可以按KEY1键将内存
释放掉。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
Press KEY_UP key to apply for memory, memory application can be used after success, press KEY0 key
That is to use the applied memory. When the use of memory is complete, you can press KEY1 to store the memory.
Release.)
- 2020-06-24 06:00:02下载
- 积分：1
-
ADC_dispay
说明： C8051F330采集软件ADC采集软件(ADC Capture Software)
- 2020-11-29 22:49:28下载
- 积分：1
-
c++Code
Code TEst for Code Of C++
- 2009-12-16 22:29:12下载
- 积分：1
-
key
基于stm32vct6的4*4矩阵键盘扫描程序(4*4 keyboard program for stm32vct6)
- 2013-08-28 19:12:30下载
- 积分：1
-
liu
八个发光二极管L1－L8分别接在单片机的P1.0－P1.7接口上，输出“0”时，发光二极管亮，开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮，重复循环。 (Eight light-emitting diodes L1-L8, respectively, then in the P1.0-P1.7 microcontroller interface, the output " 0" when the bright light-emitting diode, the beginning of P1.0 → P1.1 → P1.2 → P1. 3 → ┅ → P1.7 → P1.6 → ┅ → P1.0 Liang, repeat the cycle.)
- 2009-05-22 21:31:23下载
- 积分：1
-
dianji
超再生遥控-遥控步进电机正反转AB的程序(Superregeneration Remote- remote control stepper motor program AB)
- 2013-07-23 20:00:21下载
- 积分：1
