登录
首页 » matlab » find_boundary.m

find_boundary.m

于 2013-04-11 发布 文件大小:1KB
0 194
下载积分: 1 下载次数: 4

代码说明:

  find boundary of triangular mesh

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • getPDF2
    In this paper, we investigate the timing and carrier frequency offset (CFO) synchronization problem in decode and forward cooperative systems operating over frequency selective channels. A training sequence which consists of one orthogonal frequency-division multiplexing (OFDM) block having a tile structure in the frequency domain is proposed to perform synchronization. Timing offsets are estimated using correlation-type algorithms. By inserting some null subcarriers in the proposed tile structure, we propose a computationally efficient subspace decomposition- based algorithm for CFO estimation. The issue of optimal tile length is studied both theoretically and through simulations. By judiciously designing the tile size of the pilot, the proposed algorithms are shown to have better performance, in terms of synchronization errors and bit error rate, than the time-division multiplexing-based training method and the computationally demanding space-alternating generalized expectation-maximization
    2010-08-11 18:46:04下载
    积分:1
  • modulation
    其中给出了多种调制方式的调制及解调程序,对初学者有一定帮助。(Which gives a wide range of modulation of the modulation and demodulation process, has a certain extent, help for beginners.)
    2007-08-22 08:55:50下载
    积分:1
  • miller-rabin
    this is miller rabin source code
    2012-05-04 03:07:23下载
    积分:1
  • Eworkzipx
    实验程序MATLAB的图像变换和频谱分析,运运行的是有利于通过。,可以直接使用。 (The experimental procedure of MATLAB image transformation and spectral analysis, transport run is conducive to the adoption. Can be used directly.)
    2012-05-21 23:03:22下载
    积分:1
  • QAM
    编写一个含QAM传输的发送和接收模块 1)分别采用复基带仿真和实带通仿真两种形式 a) 实带通仿真时, 载波频率为符号率的4倍 b)发端采用滚降系数0.5的根号升余弦滤波器 2)画出Eb/N0=15dB时的接收波形(收滤波前),取100个采样 3)画出发端输出的眼图和收端过匹配滤波后的眼图(画眼图时不加噪声) 统计误符号率和误比特率与Eb/N0的关系,画出曲线, 与理论计算的曲线相对比 (Prepare to send of one with QAM transmission and receiver module 1), respectively, the complex baseband simulation and the real band-pass simulation in two forms a) the real band-pass simulation, the carrier frequency used for the symbol rate of 4 times b) the originator roll-off factor of 0.5 root raised cosine filter, 2) draw Eb/N0 = 15dB when the received waveform (closing filter), take 100 samples) to draw the originator of the output eye diagram and income side of the eye diagram after the matched filter ( draw the eye diagram without noise) statistics symbol error rate and bit error rate and Eb/N0, draw a curve calculated with the theoretical curve compared)
    2012-05-29 16:51:47下载
    积分:1
  • FastICA
    独立成分分析的算法FastICA法(也叫固定点算法)(Independent component analysis algorithm FastICA method (also called fixed-point arithmetic))
    2014-12-23 09:20:33下载
    积分:1
  • CE_in_Commun
    基于块状导频的信道估计,包含MMSE等算法。(Based on the pilot block channel estimation, including the MMSE and other algorithms.)
    2008-03-17 16:51:41下载
    积分:1
  • ofdmcomp
    Comparison of bit error rate using OFDM and BPSK
    2010-10-15 10:23:45下载
    积分:1
  • shulongdianji
    This is the MATLAB platform on setting up the simulink model. Hope everyone to correct mistakes
    2012-10-31 10:25:40下载
    积分:1
  • map
    这是一篇关于ml和map的超分辨率重建算法的文档,详细介绍了经典map重建算法和基于参数估计的算法。(map,super-resolution )
    2012-04-29 15:44:56下载
    积分:1
  • 696516资源总数
  • 106409会员总数
  • 8今日下载