-
ex4
关于自适应滤波的算法仿真，其中应用了LMS算法和RLS算法，也比较了他们的性能(Adaptive filtering algorithms on the simulation, which applied the LMS algorithm and RLS algorithm, also compare the performance of their)
- 2009-09-19 15:47:52下载
- 积分：1
-
123426
注水算法是根据某种准则，并根据信道状况对发送功率进行自适应分配，通常是信道状况好的时刻，多分配功率，信道差的时候，少分配功率，从而最大化传输速率。本文运用matlab通过对注水算法在mino系统中的三种不同的情况下进行了仿真，比较出在小信噪比时，相同信噪比下利用CSI的功率注水算法获得容量优于未知CSI的平均功率分配算法；相同容量下已知CSI信噪比比未知CSI时的信噪比小3dB.当信噪比增大到一定程度时，功率注水算法所获得的信道容量将收敛到平均功率分配的信道容量。(Water flooding algorithm is based on certain standards, and according to the channel condition to adaptive allocation of sending power, usually is a good moment, channel situation more distribution power, channel is poor, less power distribution, so as to maximize the transmission rate. This paper USES matlab based on water flooding algorithm in Austin system of three different cases are simulated and compared in small SNR, under the same SNR use CSI power allocation algorithm for capacity is superior to the average power allocation algorithm of unknown CSI Same capacity known CSI signal-to-noise ratio than the unknown CSI small signal-to-noise ratio of 3 db. When the signal-to-noise ratio increases to a certain degree, the power allocation algorithm for channel capacity will converge to the average power distribution channel capacity.
)
- 2013-09-03 20:28:15下载
- 积分：1
-
drtoolbox-use
drtoolbox降维工具箱程序包以及使用的范例 LLE，LTSA，ISOMAP，等( examples of drtoolbox use)
- 2013-10-06 10:37:07下载
- 积分：1
-
FDTD2D
一个FDTD二维的经典程序，非常不错，适合初学者使用。(A classic two-dimensional FDTD program, very good, suitable for beginners.)
- 2011-01-23 11:29:28下载
- 积分：1
-
PCA-matlab
此程序为用于主成分分析的matlab程序，可以输出贡献率及画出二维散点图(this procedure for the Principal Component Analysis Matlab procedures can export contribution rate and the two-dimensional plot paint)
- 2006-11-01 10:50:43下载
- 积分：1
-
MATLABPart1
introduction to matlab.
- 2011-11-24 12:25:19下载
- 积分：1
-
vhdl_fir
在matlab仿真的基础上，用maxplus2实现等波纹法的程序代码(In matlab simulation, based on the use of such corrugated maxplus2 realize law code)
- 2008-05-21 20:30:35下载
- 积分：1
-
pls1
matlab案例，可以用于pls模型的建立(matlab case model can be used to pls)
- 2010-09-30 16:06:46下载
- 积分：1
-
ycx
matlab7.0从入门到精通配书光盘源程序(matlab7.0 books from the entry to the master CD-ROM with source code)
- 2011-01-09 10:47:17下载
- 积分：1
-
matlab-raytrace
射线追踪,包含了起点和终点的射线函数，对于地震传播研究具有重要意义！(Raytracing in a v(z) world. The toolbox contains functions forshooting fans of rays and functions for tracing rays with specific start and end points. General multi-bounce rays with any number of mode conversions can be traced. Automatic routines for P-P and P-S primaries in shot-gather geometry are provided for convenience. Any recording geometry can be used but most functions
vectorize (e.g. are most efficient) for shot-gather geometry. Only
traveltimes and rayparameters are detemined, not amplitudes. In these routines, the velocity models should be considered as "background" models. This means that the depths at which flections and mode conversions occur are dependent of the depths given as layer boundaries in the velocity models. Velocity models are specified by a vector of velocities and a same-size vector of depths. The j th velocity is in effect from the j th to the j+1 th depth.
The bottom of the model is assumed at infinite depth. Thus v=5000
and z=0 specifies a cons)
- 2013-09-16 08:15:48下载
- 积分：1
|
联系客服（QQ：3324461878）
