-
LSM_bandcut50
自适应均衡器的仿真程序：在120hz信号下去处50hz干扰(adaptive equalizer Simulation : 120hz signal on the Department 50hz interference)
- 2007-06-26 23:05:08下载
- 积分：1
-
AFD1
单相光伏并网发电系统电压前馈控制和有源频率偏移（AFD）孤岛检测法的simulink仿真模型，初步实现了并网电流与电网电压的同频同相，AFD孤岛检测方法采用S函数给出，检测功能基本实现。(Single-phase grid-connected PV system voltage feedforward control and active frequency offset (AFD) simulink simulation model islanding detection method, the initial realization of grid current and the grid voltage of the same frequency and phase, AFD islanding detection method using the S function to out detection realized.)
- 2014-01-16 11:23:07下载
- 积分：1
-
4x4_MIMO
该程序给出了一个4*4_MIMO的实现，包含802.11n信道模型和AWGN信道模型，同时给出了在此模型下的时频估计计算，最后得到信噪比与误码率之间的关系曲线图。(The program gives a 4* 4_MIMO of implementation, including 802.11n channel models and AWGN channel model, while at the same time gives this model the frequency estimation is calculated, and finally get to noise ratio and bit error rate curve between Figure.)
- 2021-03-03 12:49:33下载
- 积分：1
-
Rosenbrock
The Rosenbrock function is a non-convex function used as a performance test problem for optimization algorithms introduced by Rosenbrock (1960). It is also known as Rosenbrock s valley or Rosenbrock s banana function.
The global minimum is inside a long, narrow, parabolic shaped flat valley. To find the valley is trivial. To converge to the global minimum, however, is difficult.
- 2011-08-03 22:48:30下载
- 积分：1
-
Dock_Sever_Simulation
用matlab自己写的码头油轮装卸载仿真程序。(err)
- 2007-12-28 17:39:06下载
- 积分：1
-
node
自适应算法是一种新的算法，本程序提供了该算法去噪功能，用处广泛。(reducing the noise using the self-adaptation)
- 2009-06-13 14:19:32下载
- 积分：1
-
unified
统一混沌系统的simulink文件可以自己改变参数(unified chaotic system Simulink documents themselves can change the parameters)
- 2006-11-13 18:34:40下载
- 积分：1
-
tiqubizhi
一个很好的关于提取币值的文章。一个很好的关于提取币值的文章。(
A very good on the extraction value of the article. A very good on the extraction value of the article.
)
- 2012-02-07 00:09:37下载
- 积分：1
-
CAPONWAVE
波束形成就是从传感器阵列重构源信号。（1）、通过增加期望信源的贡献来实现；（2）、通过抑制掉干扰源来实现。经典的波束形成需要观测方向(期望信源的方向)的知识。盲波束形成试图在没有期望信源方向信息的情况下进行信源的恢复。
波束形成技术的基本思想是：通过将各阵元输出进行加权求和，在一时间内将天线阵列波束“导向”到一个方向上，对期望信号得到最大输出功率的导向位置即给出DOA估计。
虽然阵列天线的方向图是全方向的，但阵列的输出经过加权求和后，却可以被调整到阵列接收的方向增益聚集在一个方向上，相当于形成了一个”波束”。这就是波束形成的物理意义所在。
()
- 2007-07-23 15:54:06下载
- 积分：1
-
hyperspectral-data-processing
高光谱数据处理基本算法，异常点检测，端元提取，丰度图K均值聚类，PCA算法(anomalydetection endmemberExtraction Kmeansclustering by abundancemap PCA NAPCA)
- 2011-11-21 20:06:47下载
- 积分：1
