DigitalbasebandtransmissionsystemimplementationMAT
数字基带传输系统的MATLAB仿真实现
function [sampl,re_sampl]=system_1(A,F,P,D,snr,m,N)
输入变量A ,F,P分别为输入信号的幅度、频率和相位，D为量化电平数，snr
为信道信噪比，N为D/A转换时的内插点数；输出变量sampl为抽样后的输入
信号，re_sampl为恢复出的输入信号。
数字基带传输系统的MATLAB仿真实现
[sampl,quant,pcm]=a_d_1(A,F,P,D)
[changed_ami]=signal_encod_1(pcm)
[ami_after_channel]=channel_1(changed_ami,snr)
[adjudged_ami]=adjudg_1(ami_after_channel,m)
re_pcm=signal_decod_1(adjudged_ami)
[re_voltag,re_sampl,re_sampl1]=d_a_1(re_pcm,sampl,D,N)(Digital baseband transmission system implementation MATLAB simulation function [sampl, re_sampl] = system_1 (A, F, P, D, snr, m, N) input variables A, F, P, respectively, for the input signal amplitude, frequency and phase , D to quantify the number of electric-ping, snr for the channel signal to noise ratio, N to D/A converter when the interpolation points output variables for the sample after Sampl input signal, re_sampl for the restoration of the input signal. Digital baseband transmission system simulation MATLAB implementation [sampl, quant, pcm] = a_d_1 (A, F, P, D) [changed_ami] = signal_encod_1 (pcm) [ami_after_channel] = channel_1 (changed_ami, snr) [adjudged_ami] = adjudg_1 (ami_after_channel, m) re_pcm = signal_decod_1 (adjudged_ami) [re_voltag, re_sampl, re_sampl1] = d_a_1 (re_pcm, sampl, D, N))
- 2009-03-15 18:45:46下载
- 积分：1
example4_6
：滤波
fs=400 采样频率,必须大于两倍基带信号最高频率
ts=1/fs 采样时间间隔
T=5 时间窗大小
t=0:ts:T (hf1=zeros(1,N)
hf1(f<=B1&f>=-B1)=1
y1=hf1.*fftshift(y)
figure
subplot(211)
plot(f,abs(fftshift(y))/N,f,hf1, r-- )
axis([-fs/2,fs/2,0,1.2])
title( 原信号频谱 )
xlabel( f /Hz )
subplot(212)
plot(f,abs(y1)/N)
title( 低通滤波，截止频率90Hz )
xlabel( f /Hz ))
- 2010-05-25 20:58:05下载
- 积分：1
