-
基于LabVIEW的通用自动测试系统设计
说明： 基于LabvIEw的通用自动测试系统(ATs)舍计算机，可鳊程激励、响应数据采集及uuT模块，采用MxI总线控制方式。专用信号发生器为uuT提供模拟激励信号，矩阵开关和适配器完成不同信号间切换。主控计算机执行测试程序，信号发生器发送激励信号，数据采集卡采集数据，采集数据经调理后，并与标准数据|匕较是否满足相应测试结果。(The general automatic test system (ATs) based on LabvIEw can be used as a computer to excite, respond to data acquisition and uuT module. The control mode of MxI bus is adopted. Special signal generator provides analog excitation signal for uuT, matrix switch and adapter complete switching between different signals. The main control computer executes the test program, the signal generator sends the excitation signal, the data acquisition card collects the data, after the data acquisition is adjusted, and compares with the standard data | dagger whether it meets the corresponding test results.)
- 2020-10-24 12:27:23下载
- 积分：1
-
例6.4 提取指定的波形数据
提取指定的波形数据,程序为《labview2015程序设计从入门到精通》内的例程，labview2015编译环境下编写的程序，对初学者很有用(Extract the specified waveform data, the program for "labview2015 programming from entry to master" routines, labview2015 compiler environment written procedures, useful for beginners)
- 2017-10-21 18:31:33下载
- 积分：1
-
upper-computer
研华板卡的上位机labview程序，适合labview入门(upper computer labview program based yanhua company)
- 2021-04-07 11:19:01下载
- 积分：1
-
Multiple Connections - Server
LabVIEW服务器界面，是实现LabVIEW TCP服务器程序的主界面。(The LabVIEW server interface is the main interface to realize the LabVIEW TCP server program.)
- 2018-05-08 19:13:36下载
- 积分：1
-
labview-capacity
labview vi程序，基于版本8.2可以直接运行，,用来仿真电容充放电过程(labview vi program, based on version 8.2 can be run directly, to simulate capacitor charging and discharging process)
- 2013-08-03 12:04:12下载
- 积分：1
-
server
LabVIEW里实现服务器功能，后面还有客户机(server)
- 2010-05-07 21:16:59下载
- 积分：1
-
PDsource
1）本程序为高压电气设备局部放电领域中的信号源软件模拟程序。2）本人亲自编写。实验室一直在用。3）可模拟各种类型的放电信号。4）算法此处就不提供了，否则过于泄密了。(A) the procedures for the high-voltage electrical equipment in the field of partial discharge source software simulation program. 2) I personally prepared. Laboratory has been in use. 3) to simulate various types of discharge signal. 4) algorithm is not provided here, otherwise too leaked it.)
- 2013-09-05 16:46:25下载
- 积分：1
-
NewportESP
NewPort平移台ESP301的控制程序，根据说明书自己编写的，不当之处请指正，串口通信，附有说明书。(Cord for Newport ESP301.)
- 2021-01-02 17:18:56下载
- 积分：1
-
309
说明： Labview battery tester
- 2021-03-17 22:14:01下载
- 积分：1
-
USB-RAW---Bulk-ch341
labview中usb raw设备的读取和写入程序 非常有用(labview usb raw device in the read and write process is very useful)
- 2021-04-25 10:58:46下载
- 积分：1
