-
PMSM
基于Simulink的永磁同步电机的直接转矩控制的调速仿真，里面用S函数自建部分模块，加快了仿真速度。(Simulink-based permanent magnet synchronous motor direct torque control of the speed of simulation, which used self-built part of the S-function module to speed up the simulation speed.)
- 2020-06-30 10:40:02下载
- 积分：1
-
GetEleDataFrmLL
输入经纬度，获取该处高程数据的Simulink模块，可以直接调用，两个输入一个输出(a simuink model with latitud and longitude input and elevation output, can be directly connected into your simulink model.)
- 2012-11-05 08:25:52下载
- 积分：1
-
bdf_reader_matlab_lorig
matlab code for emg signal not full
- 2009-05-01 02:36:43下载
- 积分：1
-
微电网下垂控制
微电网下垂控制，以及对比了PQ控制分别对微电网控制的影响的matlab仿真实验(Microgrid droop control and MATLAB simulation experiment on the influence of PQ control on Microgrid control are compared)
- 2021-03-18 15:09:20下载
- 积分：1
-
yy
说明： 基于matlab语音短时频谱分析，到谱分析，语谱图分析及结果(Matlab voice-based short-time spectral analysis, the spectral analysis, spectrum analysis and the results of language)
- 2008-04-08 10:27:16下载
- 积分：1
-
PCA1221
PCA用于故障检测与诊断，真的很有用，有效地检测故障(PCA for fault detection and diagnosis, really useful, effective fault detection)
- 2021-01-26 16:28:36下载
- 积分：1
-
calic.tar
calic image compression
- 2013-11-18 15:29:12下载
- 积分：1
-
TLS
本程序给出了波束形成的TLS算法，并对其进行了仿真。(This procedure gives the beamforming TLS algorithm and its simulation.)
- 2010-06-07 15:48:26下载
- 积分：1
-
MATLAB_2
主要内容：
概述
创建向量
创建矩阵
向量和矩阵元素的索引（重点）
向量和矩阵的基本操作 （重点）
多维数组
(failed to translate)
- 2009-04-05 21:38:38下载
- 积分：1
-
Optimalreceptionofadditivewhite
本设计主要对4PSK调制方式的信号，利用MATLAB的m文件进行最佳接收机的设计与仿真。对输入的叠加噪声的4PSK调制信号进行接收，利用相关解调器来实现信号解调，及最大似然准则来实现检测器。在相关解调器中，接收信号分别与基函数 和 相乘再积分。在检测器中，利用相位来判断输出，从而最终得到接收的数据。采用随机二进制数通过4PSK调制后叠加高斯白噪声再对设计的接收机进行测试，从测试的结果可看出，在信噪比大于-8dB时，误码率为0，说明该接收机较好的实现了抗噪声性能。(The design of the main 4PSK modulation mode of the signal, the use of MATLAB m file for the best receiver design and simulation. The 4PSK modulated signal of the input superimposed noise is received, and the demodulator is realized by the relevant demodulator, and the maximum likelihood criterion is used to realize the detector. In the associated demodulator, the received signal is multiplied by the basis function and multiplied by the basis function. In the detector, the output is judged by the phase, and finally the received data is obtained. Using the random binary number through 4PSK modulation after the superposition of white noise and then the design of the receiver to test the test results can be seen in the signal to noise ratio greater than-8dB, the bit error rate is 0, indicating that the receiver is better The realization of the anti-noise performance.)
- 2020-10-24 00:07:22下载
- 积分：1
