登录
首页 » matlab » MATLAB-SOFTWARE-TOOL-FOR-NEURO-FUZZY-IDENTIFICATI

MATLAB-SOFTWARE-TOOL-FOR-NEURO-FUZZY-IDENTIFICATI

于 2013-12-04 发布 文件大小:150KB
0 161
下载积分: 1 下载次数: 6

代码说明:

  NEURO-FUZZY IDENTIFICATION TOOLBOX

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • GUI-matlab
    是matlab 的GUI编程中文参考手册,很实用的(gui-matlab)
    2009-05-28 00:19:24下载
    积分:1
  • Potential_matlab
    path planning by potential field method
    2012-05-17 22:28:01下载
    积分:1
  • __Kernel_based_Data_Fusion
    第4个:matlab 和C++联合用于SVM,另外一种风格的(the 4 file: matlab and c++ together for SVM)
    2011-12-28 09:51:31下载
    积分:1
  • toupiea
    Scalp EA, very classic and practical, like friends can be learn about
    2015-03-31 16:01:04下载
    积分:1
  • xiao
    MATLAB的迭代静校正代码,原创……………………(MATLAB iterative static correction code, original ... ... ... ... ... ... ... ...)
    2010-08-30 18:44:20下载
    积分:1
  • super_matrix
    说明:  利用最小二乘法求解超定方程的矩阵解法,用matlab编写。(The least square method for solving overdetermined matrix equation solution, prepared with matlab)
    2010-04-17 10:36:14下载
    积分:1
  • Extract_test_IMFCC
    这是提取IMFCC的matlab程序,里面包含一些子函数,可以从我上载的其他资源中找到(The programming of calculating IMFCC using matlab, with some subfunctions which can find in other codes on this web)
    2013-11-17 10:16:42下载
    积分:1
  • GPS
    利用Matlab生成GPS C/A 码的基带信号。 (1)产生卫星PRN 号码为“5”的一组C/A 码; (2)循环生成25 页的导航数据,GPS 时间可填入一固定的已知数值; (3)生成C/A 码扩频信号,每个C/A 码码片给出4 个采样数据; (4)基带信号采用方波信号,电平为0 和1,占空比为50 %,不加入噪声,进一步生成某个特定的中频信号。(Matlab generated using GPS C/A code base band signal. (1) generation of satellite PRN number is " 5" a set of C/A code (2) loop generates 25 of the navigation data, GPS time can fill a fixed known value (3) to generate C/A code spread spectrum signal, each C/A code chip gives the four sampling data (4) baseband signals using square wave signal, level 0 and 1, 50 duty cycle, not to join the noise generated further a specific frequency signal.)
    2020-11-29 15:29:29下载
    积分:1
  • dwt
    研究中我么采用分段的方法对数字音频信号嵌入水印。为便于研 究,以灰度图像为数字水印原始信号经二值化处理后得到水印再嵌入 音频信号的离散变换域中,从而得到嵌入水印的音频信号,其实现过 程原理框图如图1 所示。在水印嵌入的过程主要实现四个阶段的任 务:(1)数据准备与预处理,主要是准备好水印原始图片和待嵌入水印 的音频信号 (2)音频信号分段处理,用于嵌入水印的音频数据部分等 分成(m1*m2)个音频数据段 (3)水印图像降维处理,在此过程灰度图像 水印转化为二值图象, 要将其嵌入到一维的数字音频信号中, 必须将 二维的图像转化成一维的序列 (4)将水印嵌入到数字音频信号中,从而 最终获得带数字水印的音频信号。(The study I Mody, segmented digital audio signal embedded watermark. Discrete transform domain to facilitate the study of the grayscale image for the digital watermark the original signal is obtained after the binarization processing watermark embedded in the audio signal, thereby obtaining the watermark embedded in the audio signal, and its implementation process schematic block diagram shown in Figure 1. Mainly in the watermark embedding process to achieve the task of four phases: (1) The data preparation and pretreatment, is ready to watermark the original picture and to be embedded in the audio signal of the watermark (2) audio signal segment processing for embedding watermark The audio data portion is divided into (m1* m2) audio data segment (3) The watermark image dimension reduction processing, binary image is converted to grayscale image watermark in this process, and to be embedded into a digital audio signal of a one-dimensional , two-dimensional images must be converted in)
    2013-03-19 21:11:22下载
    积分:1
  • fft
    说明:  FFT实现频谱图FFT实现频谱图 FFT实现频谱图FFT实现频谱图(FFT FFT FFT)
    2021-04-18 10:38:57下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载