登录
首页 » PDF » DVB_S2-LDPC

DVB_S2-LDPC

于 2011-12-04 发布 文件大小:4719KB
0 181
下载积分: 1 下载次数: 24

代码说明:

  讨论了LDPC码的基本编码译码原理,然后重点阐述了DVB-S2标准LDPC码的编译码方法。提出了针对DVB-s2标准的LDPC码编 码算法的软件实现 (Paper discusses the basie Principle of LDPC encoding and deocding in the standard of DVB-s2. )

文件列表:

DVB_S2中LDPC码的编码及实现.nh,5358576,2011-09-10

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • hysteresis_loop
    描述铁电薄膜的极化与电场关系(即电滞回线图)(Description of ferroelectric thin films hysteresis loops)
    2010-06-24 10:58:48下载
    积分:1
  • fangzhenliezi
    于群仿真MATLAB/Simulink书上列子(simulation )
    2021-05-14 06:30:02下载
    积分:1
  • ch01_2ed
    CHAPTER 1- real-Time Digital Signal Processing: Implementations and Applications, Second Edition by Sen M. Kuo, Bob H. Lee & Wenshun Tian, ISBN 0470014954
    2009-03-21 21:45:45下载
    积分:1
  • chapter42
    并行运算与神经网络——基于CPU/GPU的并行神经网络运算(Artificial Neural Networks)
    2014-08-25 22:56:42下载
    积分:1
  • 大跨结构、高耸结构随机风荷载数值模拟
    大跨结构、高耸结构随机风荷载数值模拟,方便快捷、使用。(Span structures, the towering structure stochastic numerical simulation of wind loads, convenient to use.)
    2010-12-03 15:13:27下载
    积分:1
  • kannumfcc
    Project of my mtech partner computer store
    2014-10-14 14:36:35下载
    积分:1
  • HMM
    HMM识别孤立词的研究与实现,有助于学习语音识别(HMM isolated word recognition and implementation of research, contribute to learning speech recognition)
    2013-09-05 13:06:15下载
    积分:1
  • chengxu
    小波变换进行变速箱故障诊断 首先将s1和s2信号时域谱(s1代表维修前的振动信号,s2代表维修后的振动信号),画出来进行对比,会发现s1信号的振动幅值会比较高;然后对s1和s2分别进行小波分解并画出各层的时域谱,只对比s1和s2分后的最高时域谱,s2更加的具有周期性,且幅值较小,s2周期性不够明显,且振动过于密集。分析完时域谱后开始分析频谱,首先对原信号s1和s2fft转换,得到频谱图,如图,然后再对小波分析后高频部分进行fft转换,做出频谱图。对比后我们发现,在f 2375HZ出(也就是齿轮的啮合频率),s1信号频谱幅值会有急剧的升高,然后,其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
    2017-01-17 19:18:02下载
    积分:1
  • matlabfunction
    这是一本对MATLAB函数语句进行说明的一本电子书(This is one pairs of MATLAB statements illustrate the function of an e-book)
    2009-12-06 22:57:02下载
    积分:1
  • eetop.cn_Simulink
    simulink简明教程,初步了解simulink的使用方式(simulink simple tutorial a preliminary understanding of the usage simulink)
    2010-01-14 13:16:41下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载