-
matlabtutorial
matlab教程，详细介绍matlab的入门到精通的过程(matlab tutorials matlab detail the process of entry to the master)
- 2010-05-14 16:35:29下载
- 积分：1
-
k-means
用c程序和matlab分别试验一种k-means改进算法，按照方法选取聚类中心点，事实证明，这种改进是有效的。(Matlab with c procedures and were experimenting with an improved k-means algorithm, in accordance with the method of selecting cluster center, the facts show that this improvement is effective.)
- 2010-05-30 22:18:05下载
- 积分：1
-
NEWwork1
认知无线电 2比特量化 EGC 硬判决仿真(Cognitive radio, two-bit quantization the EGC hard judgment simulation)
- 2012-07-22 13:16:00下载
- 积分：1
-
hex2float
16进制转浮点的SIMULINK模型。
希望对大家有用！(16 SIMULINK model of binary floating point turn. Hope to be useful!)
- 2010-09-23 08:37:03下载
- 积分：1
-
xindiantu
利用matlab模拟出心电图，并对心电图做相应处理！(Using matlab simulated ECG, electrocardiogram and accordingly deal with!)
- 2009-11-19 21:17:06下载
- 积分：1
-
pso-lsssvm
说明： 用粒子群算法选择支持向量机的参数（来自于互联网，在此感谢原创）(With the particle swarm algorithm to select the parameters of support vector machines (from the Internet, would like to thank the original))
- 2011-03-15 15:52:04下载
- 积分：1
-
AnalysisofLinkages
说明： 机械工程设计中对于连杆机构的运动分析的相关程序(Mechanical Engineering Design movement for linkage analysis procedures)
- 2010-05-03 10:30:48下载
- 积分：1
-
FFTPLOT
ieksu saze 3faze in matlab simulink
- 2013-08-21 15:52:03下载
- 积分：1
-
BOREHOLE
该程序是在flac下运行的，没找到flac，所以用matlab表示了，供岩土力学研究方向学习(The program is run under flac, did not find flac, so use matlab shows for rock mechanics research study)
- 2015-01-05 21:07:38下载
- 积分：1
-
windfarm_synmc-psl
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:52:32下载
- 积分：1
