登录
首页 » matlab » BLEAQ

BLEAQ

于 2015-01-17 发布 文件大小:44KB
0 186
下载积分: 1 下载次数: 12

代码说明:

  Efficient Evolutionary Algorithm for Single-Objective Bilevel Optimization

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • snr
    自己编的一个计算信噪比的程序,可用于相应模型的功率谱估计(Made themselves a calculated signal-to-noise ratio of the program can be used for the power spectrum of the corresponding model estimates)
    2012-11-28 19:34:55下载
    积分:1
  • files
    siùulink files of wind turbine
    2012-04-15 07:45:15下载
    积分:1
  • spline_matlab
    该程序是利用MATLAB编写,用于三次样条曲线的生成。(The program is written in MATLAB for the cubic spline curve generation.)
    2011-06-25 18:26:28下载
    积分:1
  • Schaums-Outlines---Linear-Algebra-Fourth-Edition
    Schaum s Outlines Linear Algebra,Fourth Edition
    2014-11-06 17:24:00下载
    积分:1
  • MIMO-channel-matlab
    MIMO channel model and capacity
    2011-11-04 06:49:51下载
    积分:1
  • 7d59499cc1b6
    mo phogn trong matlab
    2010-11-01 17:50:12下载
    积分:1
  • chap2_8
    在过程控制中,按偏差的比例(P)、积分(I)和微分(D)进行控制的PID控制器(亦称PID调节器)是应用最为广泛的一种自动控制器。(In process control, according to the percentage of deviation (P), Integral (I) and differential (D) control of PID controller (also known as PID regulators) is the most widely used of an automatic controller.)
    2008-07-23 23:36:23下载
    积分:1
  • MOSGA1
    基于NSGA方法的多目标遗传算法程序,本程序为通用包,可自行修改.(NSGA method based on multi-objective Genetic Algorithms procedures, the procedures for the general packet may amend its own.)
    2007-04-28 12:07:39下载
    积分:1
  • Achirplet_anad
    针对信号自适应chirplet分解未知参数多、实现起来比较困难的特点,文献[1]提出了一种新的chirplet分解快速算法。该算法利用计算信号的二次相位函数,得到其能量分布集中于于信号的调频率曲线上的结论,此时通过谱峰检测可同时获得chirplet调频率、时间中心和幅度的估计;然后通过解线性调频技术获得其初始频率和宽度的估计,仿真结果验证了本文算法的有效性。 (For the signal adaptive the chirplet decomposition of unknown parameters to achieve difficult to literature [1] proposed a new fast algorithm for chirplet decomposition. The algorithm makes use of the secondary phase of the calculated signal function, the conclusion focused on energy distribution curve to tune the frequency of the signal by the peak detection chirplet tune frequency, time center and amplitude estimates then by solving chirp technology to obtain the initial frequency and width is estimated that the simulation results demonstrate the effectiveness of the proposed algorithm.)
    2012-09-09 21:47:26下载
    积分:1
  • pwl
    利用MATLAB计算轴承故障仿真信号功率谱的相关程序。(Correlation program calculation and Simulation of signal power spectrum of bearing fault using MATLAB.)
    2015-03-20 16:53:13下载
    积分:1
  • 696516资源总数
  • 106642会员总数
  • 12今日下载