登录
首页 » matlab » imag_improve_rgbss

imag_improve_rgbss

于 2012-10-20 发布 文件大小:1KB
0 192
下载积分: 1 下载次数: 156

代码说明:

  本代码用于实现图片中的光照补偿,效果较好,实用性较强!(The code used for illumination compensation in the picture, better practicality!)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • data_whitening
    蓝牙物理层data whitening编码,数据白噪声化,目的是对数据进行离散化操作。(bluetooth PHY data whitening)
    2015-01-19 13:47:41下载
    积分:1
  • iccv13_super_supp_v3
    Fast Direct Super-Resolution by Simple Functions by C.-Y. Yang and M.-H. Yang [paper]
    2013-11-24 21:16:02下载
    积分:1
  • PnGen
    3G系统中,利用扩频技术来扩频的代码。即为PN码产生器的程序代码。(The code of PN generate for spread spectrum tecnology.)
    2014-02-23 19:55:52下载
    积分:1
  • LFC-main
    说明:  负荷频率控制(LFC)是调整系统的频率达到额定值(如50HZ)或/和维持区域联络线交换功率为计划值。频率稳定是电力系统电能质量的一个重要指标。负荷的任意突然变化都有可能导致系统间联络线交换功率的偏差及系统频率的波动。因此,为保证电能质量,需要一个负荷频率控制(load frequency control,LFC)系统,该系统的目的是将系统频率维持在标称值并且尽可能使控制区域之间的未计划的联络线交换功率最小。(Load frequency control (LFC) is to adjust the frequency of the system to reach the rated value (such as 50 Hz) or / and maintain the exchange power of the regional tie line to the planned value. Frequency stability is an important index of power quality in power system. Any sudden change of load may lead to the deviation of power exchange between tie lines and the fluctuation of system frequency. Therefore, in order to ensure the power quality, a load frequency control (LFC) system is needed. The purpose of the system is to maintain the system frequency at the nominal value and minimize the unplanned tie line exchange power between the control areas.)
    2021-03-17 19:38:19下载
    积分:1
  • heat
    Heat is a very important part of our life.
    2010-07-12 20:57:07下载
    积分:1
  • matlab_use
    To emmbed a Matlab code (m file) in your delphi application and send numerical values to Matlab for calculation, This file can Help.
    2015-03-11 03:38:10下载
    积分:1
  • EKF__
    基于扩展卡尔曼滤波器的永磁同步电机矢量控制matlab/simulink仿真(Extended Kalman Filter based permanent magnet synchronous motor vector control matlab/simulink simulation)
    2015-05-15 09:43:28下载
    积分:1
  • noise_reduction
    设计音频降噪算法,并用MATLAB仿真实现。 1)读入一段音频后添加噪声,必须包括两种不同的噪声,信噪比:0dB~10dB; 2)分别采用滑动平均滤波器,直接频域滤波,以及谱分析后设计滤波器滤波三种方法实现,并对比效果。 3)给出各种方案的设计依据、代码、频响曲线,以及输入输出对比图。(Audio noise reduction algorithm design, and use MATLAB Simulation. 1) Read after adding noise into an audio, it must include two different kinds of noise, SNR: 0dB ~ 10dB 2) respectively moving average filter directly in the frequency domain filtering, and the filter is designed to achieve three methods filter after spectral analysis and contrast. 3) Give the design basis, code, frequency response curve, and input and output comparison chart of the various programs.)
    2015-10-25 11:03:34下载
    积分:1
  • image-regiration
    matlab代码,和相关pdf文档,很经典(matlab code, and related pdf documents, it is a classic)
    2009-04-09 16:09:30下载
    积分:1
  • Exploring-Mathematics-with-MuPAD_MTManual10
    Using to call in matlab
    2013-08-17 08:02:12下载
    积分:1
  • 696516资源总数
  • 106562会员总数
  • 4今日下载