登录
首页 » matlab » Beamformingformovingsourcespeechenhancement

Beamformingformovingsourcespeechenhancement

于 2009-03-06 发布 文件大小:125KB
0 223
下载积分: 1 下载次数: 261

代码说明:

  争对移动声源采用波束形成进行语音增强,提出一种约束子带波束形成算法。其波束形成器基于一个软约束,其目的是要使波束指向特定的区域即声源方向。而其核心在于首先要进行声源定位,获得尽量准确的方位信息,然后构造软约束条件,用于波束形成。且在此过程中不断跟踪声源的移动情况。在构造的约束条件中,需要知道声源的二维信息,即与麦克风阵列的距离和方向角,“软”体现在对距离和方向角的确定都是在一定范围内的,有待进一步更正。(Between the mobile sound source using beamforming for speech enhancement, a constrained subband beamforming algorithm. Its beamformer based on a soft constraints, the aim is to make the beam point to a specific region that is the direction of the sound source. And its core is the first to sound source location, access to location information as accurately as possible, and then construct the conditions of soft constraints for beamforming. And in the process continuously tracking the movement of a sound source. Structure at the binding conditions, need to know the two-dimensional sound source information, that is, with the microphone array the distance and direction angle, the " soft" embodied in the distance and direction angle of the determination are within the scope must be further corrected .)

文件列表:

Beamforming for moving source speech enhancement.PDF

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • num
    通信系统中常用的号码分析文档,非常实用,且好理解。(Communication system frequently used phone numbers of documents, very practical, and easy to understand.)
    2020-11-20 21:39:37下载
    积分:1
  • setup-readme
    VISUALB BASIC 制作安装程序 ,更明白,更好用(Setup VISUALB BASIC produced a better understanding and better use)
    2009-06-29 22:49:42下载
    积分:1
  • 卫星信中数字调相信号调制方式识别方法研究
    说明:  针对数字卫星常用的 7 种通信信号调制方式(QPSK、8PSK、16QAM、32QAM、64QAM、16APSK、32APSK),对零中心归一化瞬时幅度谱密度最大值、四次方谱、幅度、高阶累积量四种特征参数进行了分析,提出了一种联合特征参数的信号调制识别方法.(Aiming at seven communication signal modulation modes commonly used in digital satellite (QPSK, 8PSK, 16QAM, 32QAM, 64QAM, 16APSK and 32APSK), four characteristic parameters of zero-center normalized instantaneous amplitude spectral density, quadratic spectrum, amplitude and high-order cumulant are analyzed, and a signal modulation recognition method of joint characteristic parameters is proposed. Method.)
    2020-06-21 09:20:02下载
    积分:1
  • jiugongwenti
    (九宫问题)在一个3×3的九宫中有1-8这8个数及一个空格随机的摆放在其中的格子里,如图1-1所示。现在要求实现这个问题:将该九宫格调整为如图1-1右图所示的形式。调整的规则是:每次只能将与空格(上、下、或左、右)相邻的一个数字平移到空格中。试编程实现这一问题的求解。((Nine-palace issues) in a 3 × 3 of the Nine-palace are 1-8 this 8 random number and the placing of a space in which the cell house, as shown in Figure 1-1. Now required to achieve this issue: the squares adjustment for the right as shown in Figure 1-1 form. Adjustment of the rules: each can only be with the spaces (upper and lower, or left, right) adjacent to a digital flat space. Test Programming to solve this problem.)
    2008-12-25 22:07:50下载
    积分:1
  • Satellite-Communications-Research-Trends-and-Open
    the satellite communication this paper introduced
    2012-12-18 07:15:33下载
    积分:1
  • indirect-addressing-method-
    详细介绍了西门子PLC的间接寻址方法,对于应用西门子PLC很有用处。(Detailed the the Siemens PLC indirect addressing method is useful for the application of the Siemens PLC.)
    2013-02-01 11:42:13下载
    积分:1
  • RFM70_receiver_code
    RFM 70 radio Transever 2.4GHz
    2013-09-27 18:50:56下载
    积分:1
  • d189cbee-0cef-466b-b2e7-a3bdccc642ee
    ICD for MTI-G IMU Sensor
    2012-01-23 23:12:23下载
    积分:1
  • OFDM
    给出了OFDM在卫星通信中的系统框图并 在Simulink中仿真实现,利用改进的CMA恒模算法进行盲均衡处理,来去除时变卫星信道对信号的影响,基于4阶累积量的方法 将OFDM信号与其他调制类型信号区分开来(OFDM is given in the satellite communication system block diagram and Simulation in Simulink using the modified constant modulus algorithm CMA for blind equalization, to remove the time-varying satellite channel on the signals, based on 4-order cumulant method OFDM signals and other types of signal modulation to distinguish)
    2020-12-02 20:19:26下载
    积分:1
  • 31175278moulationclassification
    主要是实现调制识别,区分几种常用的数字调制信号。含有两个文件夹 其一为特征参数的仿真;其二为正确识别率的仿真。文件夹key feature simulink中: 运行程序会得到各特征参数之间区分图 从图中可看到特征参数的有效性,见图。 文件夹classification rate simulink中:运行main.m文件 可以得到正确识别率 见图。(It is mainly to realize modulation recognition and distinguish several commonly used digital modulation signals. The simulation of two folders is one of the characteristic parameters, and the second is the simulation of the correct recognition rate. In the folder key feature Simulink: The running program will get the validity of the feature parameters that can be seen from the diagram, as shown in the diagram. Folder classification rate Simulink: running the main.m file can get the correct recognition rate.)
    2018-01-21 11:02:43下载
    积分:1
  • 696518资源总数
  • 105547会员总数
  • 4今日下载