-
qiongjinsuanfa
在图像处理中使用的穷尽算法对目标帧经行预测，也是运动估计的简单形式(In the end image processing algorithms used by the line on the target frame predicts a simple form of motion estimation is)
- 2010-07-09 10:28:39下载
- 积分：1
-
ANewAdvancedGeneticAlgorithmfor
A New Advanced Genetic Algorithm for Optimal unit commitment
- 2010-07-12 01:46:14下载
- 积分：1
-
TrajectoryandSpeedControl
Speed control for a specific trajectory for a robotic manipulator
- 2009-05-19 01:11:42下载
- 积分：1
-
buck-boost
buck boost varaible voltage by state space equations
- 2013-09-15 09:39:06下载
- 积分：1
-
mpptcheck
带有mppt光伏阵列的系统仿真，附件中包含参考的文档(With MPPT PV array system simulation, the reference contained in the annex to document)
- 2013-04-19 16:50:19下载
- 积分：1
-
Scnario1
BER plot for SUI channel 1-6
- 2013-12-11 18:59:34下载
- 积分：1
-
DPCA
动态PCA方法，引入动态时间l，考虑变量本身的时序自相关性，同时还分析变量之间的时序相关性,把PCA方法应用到动态数据矩阵。
(Dynamic PCA method, introducing dynamic time l, consider the timing of the variable itself autocorrelation, also analyzed the correlation between the timing variables, the PCA method is applied to dynamic data matrix.)
- 2014-01-22 15:34:37下载
- 积分：1
-
ADVANTECH
研华的PCL733 PCL734程序库，直接调用控制板卡，很好用的啊(Advantech' s PCL733 PCL734 library, direct calls to control the board, very good use ah)
- 2010-02-05 12:51:03下载
- 积分：1
-
slm
基于matlab实现语音信号的采集和处理，包括频谱分析，显示实时A声级(Based on matlab realize the voice signal acquisition and processing, including spectral analysis, display real-time A sound level)
- 2013-12-28 11:35:25下载
- 积分：1
-
TT
说明： The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:46:57下载
- 积分：1
