-
OFDM-vit
说明： OFDM的系统仿真，使用TCM编码，维特比译码。可以绘出多径延时状态下的不同信噪比的误码曲线(OFDM system simulation, the use of TCM coding, Viterbi decoding. Multipath delay can be drawn under the error curves of different signal to noise ratio)
- 2011-03-16 20:37:52下载
- 积分：1
-
ceil7
ceil program for number plate recognition
- 2013-03-09 20:39:41下载
- 积分：1
-
lorenz
lorenz simulation with matlab for nonlinear system
- 2014-11-26 04:02:35下载
- 积分：1
-
GA
说明： 本代码内容用遗传算法求解极值，包括种群的选择，遗传，变异等。(he code content using genetic algorithms to solve the extreme value, including populations of selection, genetic variation and so on.)
- 2014-12-22 22:22:49下载
- 积分：1
-
tiaoping
常用跳频，扩频信号的调制与解调，主要用于通信及数字信号处理领域(Commonly used frequency hopping, spread spectrum modulation and demodulation of the signal, mainly used in the field of communications and digital signal processing)
- 2013-04-13 20:13:57下载
- 积分：1
-
BLDC
高速磁悬浮永磁同步电机matlab仿真模型(High-speed maglev matlab simulation model of permanent magnet synchronous motors)
- 2013-07-03 10:22:05下载
- 积分：1
-
curvature
说明： 三维点云曲率计算，计算网格的高斯曲率、平均曲率及主曲率(Curvature calculation of three-dimensional point cloud)
- 2021-01-15 12:02:06下载
- 积分：1
-
component
c++通用技能编码能力提升：组件安装管理程序，已测试。(c++ generic skills coding capacity building: Component Installation Manager has been tested.)
- 2013-10-01 15:50:55下载
- 积分：1
-
pure-aloha-and-slotted-aloha
pure aloha 和slotted aloha算法的 matlab代码。结果显示了两种算法吞吐量的对比，通过修改标签数也可以得出吞吐量的变化值。
纯ALOHA协议(Pure ALOHA)
当传输点有数据需要传送的时候，它会向立即向通讯频道传送。
接收点在收到数据后，会ACK传输点。
如果接收的数据有错误，接收点会向传输点发送NACK。
当网络上的两个传输点同时向频道传输数据的时候，会发生冲突，这种情况下，两个点都停止一段时间后，再次尝试传送。
因为有太多的传输冲突.(pure aloha and slotted aloha algorithm matlab code. The results show the comparison of the two algorithms throughput, by modifying the number of labels can also come to change the value of the throughput. Pure ALOHA protocol (Pure ALOHA) When the transfer point has data to transmit, when it would have to immediately transfer to the communications channel. After receiving the data reception point will ACK transmission points. If the received data has an error, the receiver sends NACK point to point transmission. After transmission when two points on the network at the same time to the channel to transmit data, it will conflict, in this case, two points are stopped for some time, try the transfer again. Because there are too many transmission conflict.)
- 2021-04-08 18:59:01下载
- 积分：1
-
negentropy_grad
基于负熵的盲源分离源程序,对盲源分离领域属于最基本的程序(BSS based on negentropy)
- 2014-01-03 11:45:20下载
- 积分：1
