登录
首页 » matlab » low_pass_all

low_pass_all

于 2013-04-25 发布 文件大小:1KB
0 65
下载积分: 1 下载次数: 14

代码说明:

  各种窗函数的matlab仿真,包括三角窗,矩形窗,海明窗,汉宁窗等(matlab simulation of all kinds of window function)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • FFT_Convolution
    说明:  快速傅里叶变换和离散线性褶积matlab程序,可以直接调用(Fast Fourier transform and discrete linear convolution matlab program, you can directly call)
    2011-02-23 15:19:58下载
    积分:1
  • JakesTest
    说明:  一个jake信道算法程序,希望对研究这方面的同学有帮助(A jake channel algorithm procedures in the hope of the research in this area has to help students)
    2010-04-22 10:08:48下载
    积分:1
  • chengxu
    小波变换进行变速箱故障诊断 首先将s1和s2信号时域谱(s1代表维修前的振动信号,s2代表维修后的振动信号),画出来进行对比,会发现s1信号的振动幅值会比较高;然后对s1和s2分别进行小波分解并画出各层的时域谱,只对比s1和s2分后的最高时域谱,s2更加的具有周期性,且幅值较小,s2周期性不够明显,且振动过于密集。分析完时域谱后开始分析频谱,首先对原信号s1和s2fft转换,得到频谱图,如图,然后再对小波分析后高频部分进行fft转换,做出频谱图。对比后我们发现,在f 2375HZ出(也就是齿轮的啮合频率),s1信号频谱幅值会有急剧的升高,然后,其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
    2017-01-17 19:18:02下载
    积分:1
  • AcsrGui
    输电线路的始端电压和功率的求解,其滞后功率因素为0.8,根据其参数来求解响应的电压和频率(The shifting transmission line voltage and power, the power factor behind for 0.8, according to its parameters to solve the voltage and frequency response)
    2010-03-11 10:25:20下载
    积分:1
  • bfsk_ber
    说明:  bpsk仿真程序,仿真ber(误码率)等性能(bpsk simulation, emulation ber (bit error rate) and other properties)
    2010-04-23 00:39:14下载
    积分:1
  • simsim_sdm_read
    Cognitive Science SDM code
    2010-03-04 14:07:18下载
    积分:1
  • Hyperspectral-KNN-Classification-master
    说明:  高光谱图像分类,使用KNN分类器,进行分类。(For hyperspectral image classification, KNN classifier is used.)
    2020-04-01 20:27:05下载
    积分:1
  • shujuchuli
    处理数据小程序 原始信号和原始信号的FFT(Data processing procedures for the original signal and the original small-signal FFT)
    2010-10-08 10:24:45下载
    积分:1
  • gpml
    高斯过程在回归和分类问题中的应用,注释详细(Gaussian process regression and classification problems in the application, comments, details)
    2009-05-01 15:48:29下载
    积分:1
  • bollcode
    matlab计算股市的代码,可以帮助你分析股市,胜券在握!(matlab code for stocks)
    2009-05-03 08:56:40下载
    积分:1
  • 696524资源总数
  • 103759会员总数
  • 62今日下载