-
bys
有关卡调用的很好资料，希望对大家有用，一起学习(hand book)
- 2010-03-10 20:55:43下载
- 积分：1
-
taibao
光学中太保效应、近场、远场衍射matlab验证(CPIC effect optics, near field, far-field diffraction matlab verification)
- 2015-04-10 18:21:19下载
- 积分：1
-
PI_adjust
单相并网逆变器，使用无源阻尼，实现并网电流波形和电网电压波形同频同相(Single-phase grid-connected inverters, using passive damping, realize grid-connected current waveform and grid voltage waveform in the same frequency and phase)
- 2019-04-26 16:39:24下载
- 积分：1
-
exercise317_1
Plot the log-magnitude of the Fourier transform of the signal over the interval [0, π], using
a 1024-point FFT. The signal should be windowed with a Hamming window of two different
durations: 25 ms and 10 ms with the window placed at the signal’s center in each case. Show
the log-magnitude plot for each duration.
- 2015-04-17 16:16:08下载
- 积分：1
-
arrow
ARROW (5/20/2009) Draw a line with an arrowhead.
ARROW(Start,Stop) draws a line with an arrow from Start to Stop (points should be vectors of length 2 or 3, or matrices with 2 or 3 columns), and returns the graphics handle of the arrow(s). By itself, ARROW will use the mouse to allow selection.
- 2010-10-20 14:36:24下载
- 积分：1
-
gsm_fangzheng
GSM信道仿真源程序,包括各个模块(交织器,卷及码,外编码)和全信道程序(GSM channel simulation source code, including all modules (interleaver, roll and codes, encoding), and Channel procedures)
- 2007-03-12 14:34:59下载
- 积分：1
-
white_noise
生成白噪声信号：包括采样频率，最大和最小频率，时间长度，幅值等要求的信号。(Generated white noise signal: including sampling frequency, maximum and minimum frequency, duration, amplitude and other requirements of the signal.)
- 2011-08-31 14:32:12下载
- 积分：1
-
re1
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:51:25下载
- 积分：1
-
OMNetpp
Modeling and Analysis of Computer Networks Course
- 2010-07-15 08:42:28下载
- 积分：1
-
matrix_generation
Matlab packet for generating G and H matrix for RS codes in binary form
- 2009-03-14 12:27:27下载
- 积分：1
