-
correlation
采用互相关法计算相位差程序。用小波对信号进行消噪，再用互相关法检测两个信号的相位差。(Using correlation method to calculate the interval phase of two signals. Wavelet method is used for signal denoising, and then the interval phase of two signals is detected by correlation method.)
- 2012-05-21 13:41:04下载
- 积分：1
-
spline
matlab写的B样条函数的计算，计算插值点的值(matlab write B-spline calculation, the calculation of the value of interpolation points)
- 2007-09-18 09:35:37下载
- 积分：1
-
arc_model_new
电弧仿真模型，delft大学，含有mayr、cassie等6种模型(Arc model, delft university， containing mayr, cassie six kinds of models)
- 2021-01-03 21:28:55下载
- 积分：1
-
Matlab各种插值法.part6
说明： Matlab的 各种插值法..代码，Lagrange插值..Newton插值... Hermite插值...
分段低次插值... 三次样条插值 二维插值...(Various interpolation methods of MATLAB.)
- 2020-06-23 22:00:02下载
- 积分：1
-
xishaoxing
模仿人眼的视觉注意机制，以图像中的稀少点和对比度为特征，求出视觉注意点。(Mimic the human eye visual attention mechanism to image point and a contrast ratio of rare characteristics, find the point of visual attention.)
- 2010-06-07 16:42:51下载
- 积分：1
-
photonic_crystal
采用平面波展开法模拟2维光子晶体的能带结构,FDTD法模拟2维光子晶体能量传输(used plane wave expansion method for simulation of two-dimensional photonic crystal structure of the band, FDTD simulation of two-dimensional photonic crystal energy transmission)
- 2021-04-27 10:18:44下载
- 积分：1
-
timeoptimaltrajectory
The GUI is used to demonstrate the results and concepts used in the paper.
If readers want to use its result in their research for determining the minimum-length or time-optimal trajectory, just call function
- 2012-04-13 11:36:53下载
- 积分：1
-
main1
本程序用于雷达成像压缩感知算法，基于压缩感知算法的雷达探测区域成像(radar imaging based on compressed sensing)
- 2012-07-06 10:09:36下载
- 积分：1
-
可变遗忘因子
本程序为遗忘因子最小二乘法，可以拷贝至matlab的M文件中适应(Matlab for ] least square method)
- 2018-07-31 17:19:26下载
- 积分：1
-
123
用C或者matlab编写基2 FFT快速算法，输入点数是2的幂次方，序列视作既包含实部也包含虚部。要求一个函数计可以做正变换，也可以做反变换。编写输入序列，先进行正反向变换，得到离散频谱，再将离散频谱加载到输入端进行验证，从输出端获取序列，和原来的序列进行比较，看看是否相等。序列可随意设为2的幂次项！(Written by C or matlab base 2 FFT fast algorithm, the input power of 2 points is the sequence includes both the real part as the imaginary part is also included. Require a meter to do is change the function, you can also do the inverse transform. The preparation of the input sequence, first the forward and reverse transformation, discrete spectrum, discrete spectrum and then loaded into the input validation, access to sequence from the output side, and the original sequences were compared to see if equal. Sequence can be arbitrarily set to a power of 2 items!)
- 2011-01-06 21:52:49下载
- 积分：1
