登录
首页 » matlab » RK4_lor

RK4_lor

于 2012-10-30 发布 文件大小:1KB
0 216
下载积分: 1 下载次数: 14

代码说明:

  数值计算matlab例程,用RK4算法求解Lorenz方程,验证蝴蝶效应(RK4,Lorenz Equation)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • CSE_Assignment3
    I am submitting my Computational science and engineering assignment #3 based on SVD/PCA.The zip file contains matlab codes of Exercise no:1 and Exercise no:3 as program_1.m and program_3.m files respectively. I have made a separate reports for the above said two exercises as Report_problem1 and Report_problem3, both in pdf format. Please find the attached zip file.
    2011-04-20 13:38:47下载
    积分:1
  • 37724093DoubleCloseloop
    induction generator for wind turbine
    2010-05-27 02:15:16下载
    积分:1
  • adpcm
    Matlab code for implementing ADPCM modulation in an efficient manner
    2010-03-12 16:23:11下载
    积分:1
  • SPA
    SIHO的置信传播迭代解码算法SPA,可以比较数据误码率(SIHO the belief propagation iterative decoding algorithm SPA, can compare the data error rate)
    2011-05-30 20:52:19下载
    积分:1
  • apg_partial
    部分APG算法解决了核函数相关模式识别问题的例子,可加速迭代进程,减少运算时间.(An Accelerated Proximal Gradient Algorithm for Nuclear Norm Regularized Least Squares problems)
    2013-08-22 17:23:57下载
    积分:1
  • code
    设计一个信号发生器,并同时画出信号的时域表 示,自相关函数及功率谱(Design of a signal generator and simultaneously draw the time domain representation of the signal, the autocorrelation function and the power spectrum)
    2013-10-16 21:24:32下载
    积分:1
  • emd
    Emperical mode decomposition
    2015-04-22 15:34:05下载
    积分:1
  • 雷达信号处理基本流
    去斜处理(宽带的匹配滤波)Stretch方法是针对线性调频信号而提出的, 其方法是将输入信号与参考信号 (经适当延迟的本振信号, 延迟量通常由窄带信号测距结果估计出) 混频 ,则每一个散射点就对应一个混频后的单频分量,对混频输出的信号进行 DFT 处理 ,即可获得目标的距离像,对参考信号的要求是应具有与输入信号相同的调频斜率。(dechirp matched filter Stretch method is proposed for linear frequency modulation signal. It mixes the input signal with the reference signal (local oscillator signal with appropriate delay, the delay is usually estimated from the result of narrowband signal ranging). Then each scattering point corresponds to a single frequency component after mixing, and DFT is performed on the mixed-frequency output signal. The range profile of the target can be obtained by processing, and the reference signal is required to have the same frequency modulation slope as the input signal.)
    2018-10-31 20:07:27下载
    积分:1
  • KPCA11
    自己尝试编写的核主元分析(KPCA)程序(Try to write a kernel principal component analysis ( KPCA ) program)
    2012-04-19 16:43:24下载
    积分:1
  • Npso-programing-and-article
    小生境粒子群算法编程,及20篇相关论文,全都是关于小生境粒子群的研究与应用(Niche Particle swarm algorithm programming, and 20 article about NPSO s research and application)
    2020-11-21 09:49:35下载
    积分:1
  • 696516资源总数
  • 106642会员总数
  • 12今日下载