登录
首页 » matlab » fifteenlevelHbridge

fifteenlevelHbridge

于 2015-02-15 发布 文件大小:18KB
0 210
下载积分: 1 下载次数: 7

代码说明:

  matlab simulink model for a thirteen level h bridge multi level inverter

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 12
    说明:  家庭心电图仪及远程诊断系统,设计心电仪参考(Family ECG devices and remote diagnostic system, the design of ECG instrument reference)
    2009-02-14 19:49:25下载
    积分:1
  • 1CSin_OMP
    利用压缩传感技术对1-D信号进行处理,1-D信号压缩传感的实现(Compressed sensing technology using 1-D ,1-D signal processing implementation of compressed sensing signal)
    2011-01-10 10:49:17下载
    积分:1
  • QPSK_TX
    qpsk transmiter with qpska modulator QPSK is a method for transmitting digital information across an analog channel.Data bits are grouped into pairs, and each pair is represented by a particular waveform, called a symbol, to be sent across the channel after modulating the carrier.
    2011-06-14 03:31:31下载
    积分:1
  • PROG5
    MATLAB code to Import a gray scale image Decompose it into two-three sub bands,Reconstruct the original image the different subbands
    2015-01-06 02:20:33下载
    积分:1
  • Solvingslabwaveguide
    求解平板波导(对称结构)TE基模的有效折射率(Solving slab waveguide (symmetric structure) effective refractive index of the fundamental mode TE)
    2020-10-19 01:57:26下载
    积分:1
  • ltfat-0.95
    Matlab时频分析工具箱,希望能对大家有所帮助啊 (Time-Frequency Analysis Matlab Toolbox, hoping to be helpful for all of us ah)
    2008-04-27 08:29:11下载
    积分:1
  • Q3_1
    hello mr admin please active my account
    2013-11-29 15:01:03下载
    积分:1
  • EmulatedFields
    different than the fields they were declared to have.
    2014-01-17 13:03:48下载
    积分:1
  • m_k_plot
    MK检验程序,可广泛应用于气象、水文时间序列分析。(MK inspection procedures, can be widely used in meteorological, hydrological time series analysis.)
    2013-12-13 13:17:24下载
    积分:1
  • kd
    说明:  根据前人研究成果可以证明,煤镜质组反射率各向异性对煤田构造特征具有指示意义,镜质组最小反射率可以指示构造主应力方向。然而,在实际测量中,如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法,可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变,其由之前的统计方法测定得到,三个截面的数据对于拟合唯一应变椭球来说是过多的,因此不可避免出现误差,导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球,需要对得到的数据进行相容性调整。采用Oertel的方法,从每一测量参数在不同截面中的值是正态分布这一假定出发,利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)
    2014-11-12 11:06:13下载
    积分:1
  • 696516资源总数
  • 106554会员总数
  • 12今日下载