-
30621587boxcount-matlab
一维分形维数的计算，计盒数，看着好才发上来的(One-dimensional calculation of the fractal dimension, box-counting the number was made up to look good)
- 2011-09-20 17:13:02下载
- 积分：1
-
wsn
这是随进总结的关于无线传感器网络的一些算法，希望对大家有用，leach 算法编码，heed分簇算法仿真，改进的salama仿真，kNearestNeighbors仿真(here is some matlab code for wireless sensor network, for example, leach, heed, improved salama, knearestneighbors as so on)
- 2020-10-03 21:37:41下载
- 积分：1
-
pid
在simulink软件平台下搭建对系统温度实现策略控制的模型(Based on the Simulink software platform, we build a model to control the system temperature.)
- 2018-04-12 15:25:17下载
- 积分：1
-
rect_array
MATLAB Simulations for Radar Systems DesignMATLAB_Code
ect_array(MATLAB Simulations for Radar Systems Design MATLAB_Code rect_array)
- 2009-10-26 21:48:20下载
- 积分：1
-
DWT_in_matlab
小波分析理论与MATLAB R2007实现，小波变换在矩阵方程求解中的应用(Wavelet analysis theory and MATLAB R2007 implementation of wavelet transform in finding the solution of matrix equation)
- 2011-01-10 10:59:22下载
- 积分：1
-
Matlabzixue
用于自学Matlab的一些小的简单的程序，里边涵盖了许多数学问题(For self-study a number of small simple Matlab program, covers a lot of math problems inside)
- 2011-08-20 22:08:01下载
- 积分：1
-
matlab1
一个讲述MATLAB偏微分方程工具箱的 PDF 文件(A MATLAB PDE toolbox about PDF files)
- 2009-12-16 19:42:23下载
- 积分：1
-
f_qujian
simulink的仿真有两个阶段：一个为初始化，这个阶段主要是设置一些参数，像系统的输入输出个数、状态初值、采样时间等；第二个阶段就是运行阶段，这个
阶段里要进行计算输出、更新离散状态、计算连续状态等等，这个阶段需要反复运行，直至结束。(simulink simulation has two phases: one for initialization, this stage is mainly to set some parameters, such as the number of input and output system, initial state, the sampling time second stage is the operational phase, the
Stages to calculate the output, update the discrete state, continuous calculation of the state, etc., this stage requires repeated runs to the end.)
- 2011-08-31 11:15:56下载
- 积分：1
-
huffman
霍夫曼编码的具体方法：先按出现的概率大小排队，把两个最小的概率相加，作为新的概率 和剩余的概率重新排队，再把最小的两个概率相加，再重新排队，直到最后变成1。每次相 加时都将“0”和“1”赋与相加的两个概率，读出时由该符号开始一直走到最后的“1”， 将路线上所遇到的“0”和“1”按最低位到最高位的顺序排好，就是该符号的霍夫曼编码。(Specific methods Huffman coding: the probability of emergence of the size press line, the two smallest sum probability, as a new probability and the probability of re-queue the remaining, then the minimum of two probabilities are added, and then re-queue, until finally become one. Each time the sum will be 0 and 1 Fu added two probabilities, when read by the symbol has come to begin the final 1 , the route will encounter a 0 and 1 at the lowest to the highest bit of the right order, that is the symbol of the Huffman coding.)
- 2015-04-04 20:34:08下载
- 积分：1
-
fh
说明： 本文阐述了扩展频谱通信技术的理论基础和实现方法，利用MATLAB 提供的可视化
工具Simulink 建立了扩频通信系统仿真模型，详细讲述了各模块的设计，并指出了仿真建模
中要注意的问题。在给定仿真条件下，运行了仿真程序，得到了预期的仿真结果。同时，利
用建立的仿真系统，研究了扩频增益与输出端信噪比的关系，结果表明，在相同误码率下，
增大扩频增益，可以提高系统输出端的信噪比，从而提高通信系统的抗干扰能力。 (This paper describes the theory of spread-spectrum communication technology and implementation methods based on the use of visualization tools provided by MATLAB Simulink to establish a spread spectrum communication system simulation model, described in detail the design of each module, and pointed out that the simulation modeling to note problem. In the given simulation conditions, running a simulation program to obtain the desired simulation results. Meanwhile, the use of the simulation system to study the spreading gain and the relationship between the output signal to noise ratio, results show that the same bit error rate, increased spreading gain can increase the system output signal to noise ratio, thereby enhancing communication system disturbance.)
- 2010-05-06 12:31:38下载
- 积分：1
