-
ss1
说明： 声级计自动检定系统设计,介绍如何检定声级计.(Automatic verification system for sound level meter design, how to test the sound level meter.)
- 2011-03-02 12:37:14下载
- 积分：1
-
hutu
说明： 应用MATLAB的M文件编程方法过行信号频域分析。分别用矩阵运算的方法计算方波的DFS，在60的时窗宽度上方波宽度分别为5与12。并且画出x(n)和DFS(x(n))的杆状图。(Application of MATLAB M-file programming off-line signal frequency domain analysis. Were calculated using matrix calculation of square wave of DFS, in the 60' s when the window width the width of the top of wave 5 and 12, respectively. And draw the x (n) and DFS (x (n)) of the rod-shaped graph.)
- 2010-04-03 16:04:03下载
- 积分：1
-
OurAngle
该程序是将摄像机旋转矩阵反求得到欧拉角过程，算法简单，容易操作。(The program is to get the camera rotation matrix Euler angle reverse the process, the algorithm is simple, easy to operate.)
- 2011-04-19 10:01:01下载
- 积分：1
-
junyunCA
瑞利包络杂波条件下的CA-CFAR方法检测，效果不错。(Rayleigh clutter under the conditions of the envelope detection of CA-CFAR method, good results.)
- 2012-05-01 15:32:28下载
- 积分：1
-
MUSIC_LINE
实现基本MUSIC算法,加入高斯白噪声,完成信号来波方向的精确定位(achieve basic MUSIC, by adding Gaussian white noise, the complete signal wave direction to the precise location)
- 2007-06-22 09:44:38下载
- 积分：1
-
work_2
实现（2，1，7）卷积编码以及相应的viterbi译码(achieve (2,1,7) convolutional code and the corresponding Viterbi decoding)
- 2006-06-10 14:29:10下载
- 积分：1
-
MATLAB-image-and-graphics-tutorials
非常好的MATLAB教程，当你看完教程后你会发现MATLAB比其它开发语言要简单的多(MATLAB tutorial is very good, when you read the tutorial you will find MATLAB simpler than other development languages to)
- 2013-12-10 16:54:15下载
- 积分：1
-
Cone_conformal
用MUSIC算法+均匀锥面阵进行信号的DOA估计(With the MUSIC algorithm+ uniform cone array for signal estimation of DOA)
- 2009-12-08 10:54:58下载
- 积分：1
-
otsu
说明： 这是个关于图像大津法分割算法的源程序，在matlab上实现。(This is about image segmentation algorithm of Otsu' s source code, in matlab to achieve.)
- 2010-04-26 10:43:03下载
- 积分：1
-
windfarm_synmc-psl
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:52:32下载
- 积分：1
