登录
首页 » matlab » attractors

attractors

于 2011-12-27 发布 文件大小:3KB
0 185
下载积分: 1 下载次数: 13

代码说明:

  Rossler, Chua and lorenz attractors in GNU Octave

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • noiseest_matlab
    NoiseLevel estimates noise level of input single noisy image. ... In the matlab code, I did not use the toeplitz matrix to calculate the
    2014-08-19 19:27:44下载
    积分:1
  • gs
    光栅图形矢量化方法分析与评价,一篇不错的书籍(Raster graphics vector analysis and evaluation methods, a good book)
    2014-02-21 03:01:05下载
    积分:1
  • rake_simulation
    本程序对rake接收机的仿真程序 在matlab simulink下实现,其信道模型采用802.15.3a信道,信源部分的采用UWB信号,最后通过计算snr与errorbitrate来说明rake接收机性能(this program right rake receiver in the simulation program under Matlab Simulink. its channel model used 802 .15.3 a letter, the source of the signal using UWB, Finally, with errorbitrate snr calculated to illustrate rake receiver performance)
    2007-03-14 18:35:09下载
    积分:1
  • code
    用MIMO系统的空时编码仿真,matlab实现,性能对比分析(With space-time coding MIMO system simulation, matlab implementation, performance, comparative analysis)
    2013-10-06 10:00:19下载
    积分:1
  • Main
    混沌工具箱ver.2.0,程序没问题,可以用。有c-c法求时延和嵌入维数的,求最大李雅普诺夫指数的等。(Chaos Toolbox ver.2.0, the program is no problem, you can use. There cc method for delay and embedding dimension, for the largest Lyapunov exponent and so on.)
    2013-11-28 16:48:13下载
    积分:1
  • 0.618
    0.618法是根据黄金分割原理设计的,所以又称之为黄金分割法。 (0.618 method is based on the design principles of the golden section, it is also known golden section method. )
    2011-12-17 19:45:45下载
    积分:1
  • rio500_usb
    When plumbing the depths of the key tree, this sets a hard limit set on how deep we re willing to go.
    2015-06-15 14:42:47下载
    积分:1
  • CRC 循环冗余校验码
    CRC 循环冗余校验码 matlab 实现(CRC cyclic redundancy check code)
    2011-05-29 23:57:10下载
    积分:1
  • quasite
    这是使用有限差分法计算quasi TE模的程序,需要先定义波导的参数(This is the use of finite difference method quasi-TE mode procedures, the need to first define the parameters of Waveguide)
    2007-04-25 10:07:56下载
    积分:1
  • RD
    说明:  率失真函数是在给定信源和失真度量情况下,求满足保真度准则的平均信息率的极小值。本程序给出了两种特殊情况下的率失真函数的计算(Rate-distortion function is a given source and distortion measure case, seeking to meet the fidelity criteria, the average information rate of the minimum. This procedure presents two special circumstances, the calculation of rate-distortion function)
    2010-12-09 10:46:54下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载