-
an510
基于MATLAB/simulink的永磁同步电机仿真模型.空间失量磁场定向算法(Based on MATLAB/simulink simulation model of permanent magnet synchronous motor. Spatial loss field oriented method)
- 2011-01-26 00:08:13下载
- 积分：1
-
Mercurial_The_Definitive_Guide
mercurial 分布式版本控制软件指南，方便个人和工程使用，使用方便(mercurial distributed version control software)
- 2013-08-11 17:33:24下载
- 积分：1
-
BPSK3
3、 瑞利信道中的调制解调、信道估计：
(1) 请推导出单径瑞利信道中的BPSK相干解调的理论误码率性能，并画出比特信噪比与误码率的关系曲线。
(2) 在单径瑞利信道中，请设计一种时分的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与误码率的关系曲线，并与(1)的曲线进行对比。
(3, the Rayleigh channel modulation and demodulation, channel estimation:
(1) Please derive the single-path Rayleigh channel coherent demodulation of BPSK BER performance theory, and draw the signal to noise ratio and bit error rate curves.
(2) single-path Rayleigh channel, please design a division of the guide-assisted channel estimation method, using Simulink simulation, measurement of the BER performance of BPSK, draw-bit signal to noise ratio and bit error rate curve, and with (1) of the curves were compared.
)
- 2020-12-05 15:49:23下载
- 积分：1
-
A-Place-Theory-of-Sound-Localization
本文介绍了一种基于双耳时间差的短信声源定位方法。(This paper describes an approach based on interaural time difference SMS sound source localization method.)
- 2013-05-25 02:00:54下载
- 积分：1
-
NLMS
对归一化最小均方算法NLMS的matlab仿真，包括收敛曲线(The normalized least mean square algorithm NLMS matlab simulation, including convergence curve
)
- 2013-11-29 10:47:29下载
- 积分：1
-
wdxpd
上传一个判断传递函数的稳定性的程序，当传函零极点位于虚轴右侧时系统不稳定，输出不稳定提示，系统稳定时输出稳定系统的传函。(Upload a function to determine the stability of the program transfer, the transfer function when the right side of the imaginary axis pole-zero when the system is unstable, unstable output prompt, the output transfer function to stabilize the system when the system is stable.)
- 2013-12-27 16:31:12下载
- 积分：1
-
C-C-Method
这是一个matlab程序，介绍的是用CC方法重构Lorenz系统的相空间(This is a matlab program, introduced with CC method reconstruction phase space of the Lorenz system)
- 2014-02-13 00:33:55下载
- 积分：1
-
PID程序刘金琨-先进PID控制MATLAB仿真
说明： 程序使用说明
1、所有仿真算法按章归类，文件中的程序名与书中一一对应。
2、将仿真程序复制到硬盘MATLAB运行的路径中，便可仿真运行。
3、本书算法在MATLAB 5.3版下运行成功，并适用于其他版本。
4、程序chap1_11.mdl；chap3_2.mdl；chap3_5.mdl；chap6_2.mdl；chap6_4.mdl需要在Matlab6.5下运行，特此说明。
5、假如您对仿真程序有疑问，请及时通过 E-mail 与作者联系。
北京航空航天大学 刘金琨
E-mail 地址： ljk@dept3.buaa.edu.cn或ljk@buaa.edu.cn(Program instructions
1 All simulation algorithms are classified by chapter, and the program name in the file corresponds to that in the book one by one.
2 Copy the simulation program to the Matlab running path of the hard disk, then the simulation can run.
3 The book algorithm in Matlab version 5.3 run successfully, and suitable for other versions.
4 Program chap1.11.mdl; chap3.2.mdl; chap3.5.mdl; chap6.2.mdl; chap6.4. MDL needs to run under MATLAB6.5.
5 If you have any questions about the simulation program, please contact the author by e-mail.)
- 2021-03-17 12:43:35下载
- 积分：1
-
v_blast_code
simulate v_blast for mimo code
- 2013-03-04 15:18:19下载
- 积分：1
-
FRlineflow
to find a losses in tranmission line
- 2013-04-25 09:14:08下载
- 积分：1
