-
res-test
毫欧级电阻测试方法，非常详细，很多高档仪器都是这种方法做的！测试行业必备(Very milliohm resistance test method, detailed, many high-end instruments are of this method do! The test of necessary)
- 2014-04-26 20:29:13下载
- 积分：1
-
p145-chu
论文——关于支持向量序数回归的新方法 weichu(Paper- A new method weichu on support vector ordinal regression)
- 2014-12-25 13:37:18下载
- 积分：1
-
nec_part3
A Beginner’s Guide to
Modeling with NEC vol 3
- 2014-10-15 08:30:40下载
- 积分：1
-
jiashiqi
这是一款空气加湿器，经过高频振荡，把水雾化，采用台系MCU，含有原理图。是一款经过量产的优良小家电产品。(This is an air humidifier, high frequency oscillation water atomization, the Taiwan-based MCU contains schematic. After production is a good small household electrical appliances.)
- 2013-04-23 19:34:35下载
- 积分：1
-
timer
说明： 使用定时器TIM3输出四路的SPWM波，其中一二路、三四路波形一致，一二路与三四路波形相差180°(Timer TIM3 is used to output four SPWM waveforms, of which one, two, three and four waveforms are identical, and one, two and three and four waveforms are 180 degrees different.)
- 2020-06-19 18:40:02下载
- 积分：1
-
parker
基于美国PARKER运动控制器开发的多轴运动控制界面，包括直线，圆弧插补等，界面友好，直观(PARKER motion controller based on U.S. developed multi-axis motion control interface, including linear and circular interpolation, etc., user-friendly, intuitive)
- 2020-09-10 06:38:00下载
- 积分：1
-
ses
有限差分波动方程不加边界条件二阶正演时间切片程序。(Finite difference wave equation without boundary conditions of second-order forward time-slicing procedure.)
- 2009-12-11 16:54:20下载
- 积分：1
-
Untitled
通过对原始图像的水平和垂直投影图像来对车牌进行水平方向的定位(Original image through the level and vertical projection of images to the horizontal direction of the plate for the positioning of)
- 2008-05-26 21:38:45下载
- 积分：1
-
FreeRTOS实验15-1 FreeRTOS软件定时器实验
说明： 硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是
周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0
可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次，
运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is
The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0
You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once.
The run cycle will stop after that unless KEY0 is pressed to turn it on again.)
- 2020-06-24 05:00:01下载
- 积分：1
-
dianti
基于凌阳61板的五层电梯模型C语言程序，经试验成功(Sunplus based on the five-story elevator plate 61 model C Language Program Following a successful trial,)
- 2007-11-11 16:59:53下载
- 积分：1
