-
k-means
说明： 聚类方法中的K-means实现，用matlab语言实现的聚类(Clustering of K-means implementation of the cluster with matlab language)
- 2010-04-18 21:59:48下载
- 积分：1
-
mlp
neural network back propagation
- 2009-10-17 14:57:37下载
- 积分：1
-
bmpyasuo
图象压缩 huffman 编码的matlab实现程序 (image compression Huffman coding procedures to achieve the Matlab)
- 2007-05-30 15:30:35下载
- 积分：1
-
QPSK_fre_DFE_equa
频域反馈均衡器仿真设计，采用FFT快速变换，抗通信中的多径干扰(frequency decision feedback equaliter，use FFT，in order to estimate the ISI in communication)
- 2013-11-12 09:21:07下载
- 积分：1
-
Solution-24point
haskell实现24点，输出所有可能的计算式(haskell, calculating the 24 point, inputing all the method to get 24)
- 2014-11-17 22:39:34下载
- 积分：1
-
Untitled
说明： 很好用的小波分解程序，简单，对初学者很有帮助。(Nice wavelet decomposition program, for beginners helpful.)
- 2011-03-23 10:05:47下载
- 积分：1
-
5
说明： 5. 在三条径的瑞利信道中，对于直接序列扩频：
(1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与信道估计均方误差的关系曲线，画出比特信噪比与误码率的关系曲线，请解释在误码率为0.01时，两种合并方式所表现的不同的物理意义。
(2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真(自己编写代码S-Function方式)，分析所设计方案的时间同步精度，画出比特信噪比与捕获概率的关系曲线。
(3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真(自己编写代码S-Function方式)，画出比特信噪比与频率同步误差的关系曲线。
(5 In the three path Rayleigh channel, for direct sequence spread spectrum:
(1) Please design a specific DS-CDMA code division guide-assisted channel estimation, receiver, etc were used to benefit the merger, the maximum ratio combining. With the Simulink simulation, BPSK BER performance measure, draw-bit signal to noise ratio and channel estimation mean square error of the curve, draw the signal to noise ratio and bit error rate curve, please explain in bit error rate 0.01, the two methods are combined performance of the different physical meaning.
(2) frequency has been set up synchronization, a specific design of DS-CDMA single-stop sliding correlation method of time synchronization, simulation with Simulink (S-Function code their own way), analyze the design of time synchronization accuracy, draw bit signal to noise ratio and capture probability curve.
(3) set time has been synchronized, a specific design of DS-CDMA frequency synchronization method, simulation using Simulink ()
- 2011-07-20 11:02:06下载
- 积分：1
-
source
输入信号为方波信号+高斯白噪声，方波信号基 频为1kHz，幅值为1，高斯白噪声方差为0.2， 均值为0，采样频率为20kHz。试用最大熵估计 法估计此信号的AR模型及其功率谱，并分析结 果(The input signal is a square wave signal+ Gaussian white noise, square wave signal fundamental frequency 1kHz, amplitude is a Gaussian white noise variance is 0.2, the mean is 0, the sampling frequency is 20kHz. Try maximum entropy estimation method to estimate the AR model of this signal and its power spectrum, and analyze the results)
- 2013-10-29 17:50:45下载
- 积分：1
-
Retinex
本代码实现基于Retinex理论的三种方法，分别为单尺度Retinex，多尺度Retinex，以及自商图像方法。直接运行每个文件夹下的test文件就可以得到对应的方法的处理结果。(This code implements three methods based on Retinex theory, respectively, for the single-scale Retinex, the multiscale Retinex, as well as self-quotient image method. The test file can be run directly under each folder corresponds to the method of processing results.)
- 2021-04-15 13:48:54下载
- 积分：1
-
RD
说明： 机载SAR成像距离多普勒（RD）算法，自己编写的，实际数据处理效果很好。(The range Doppler (RD) algorithm of airborne SAR imaging is written by myself, and the actual data processing effect is very good.)
- 2020-09-03 09:06:18下载
- 积分：1
