登录
首页 » matlab » BP-wind-prediction

BP-wind-prediction

于 2014-01-14 发布 文件大小:17KB
0 155
下载积分: 1 下载次数: 255

代码说明:

  含NWP数值天气预报和不含NWP数值天气预报的BP神经网络预测风电功率两种方法进行比较,含数据,实际案例。(With and without NWP NWP Numerical Weather Prediction NWP BP neural network prediction of wind power are two methods were compared with the data, the actual case.)

文件列表:

BP wind prediction
..................\bp.m,1813,2014-01-07
..................\BPNWP.m,1737,2014-01-07
..................\goontest.mat,874,2013-10-12
..................\goontestNWP.mat,974,2013-10-16
..................\traindata1011.mat,6430,2013-10-11
..................\traindata1011NWP.mat,7287,2013-10-16

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • runATGP
    ATGP endmember extraction algorithm from Washington DC hyperspectral data!
    2013-08-07 03:32:54下载
    积分:1
  • field
    simulation of Field-oriented control (FOC) of induction motor using chopper
    2014-08-09 02:09:11下载
    积分:1
  • LinWPSO
    改进的粒子群算法在matlab中的应用,程序简单(Improved particle swarm algorithm in matlab, simple procedures)
    2013-04-06 20:29:12下载
    积分:1
  • smithbj
    二阶耦合系统的解耦控制,前馈解耦,带smith预估补偿解决大滞后问题。(Decoupling control system coupled second order feedforward decoupling.)
    2017-04-06 23:59:35下载
    积分:1
  • ErsBlocksGame
    这是我老师给的一些代码,在此借用了,呵呵(I m a new student )
    2010-01-11 09:34:46下载
    积分:1
  • 5
    说明:  its also about wireless sensor network
    2011-01-07 20:14:33下载
    积分:1
  • abctodq0
    三相静止坐标系变换到dqo坐标系的建模仿真(matlab/simulink)(Three-phase stationary coordinate system transformation to dqo coordinate system modeling and simulation (matlab/simulink))
    2011-05-22 14:37:37下载
    积分:1
  • rub
    该程序主要完成jeffcott转子圆周碰摩故障仿真,包括设置初始条件,转子系统参数等(rub-impacting of rotor)
    2015-06-21 18:22:20下载
    积分:1
  • Matlab
    课程设计中首先采用Ising model的思想建立一个二维的模型,然后利用重要性抽样和Monte Carlo方法及其思想模拟铁磁-顺磁相变过程。计算了顺磁物质的能量平均值Ev、热容Cv、磁化强度M及磁化率X的值,进而研究Ev、Cv、M、X与温度T的变化关系并绘制成Ev-T图、Cv-T图、M-T图、X-T图,得出顺磁物质的内能随着温度的升高先增大而后趋于稳定值;热容Cv、磁化率X随着温度的升高先增大后减小;磁化强度M在转变温度Tc处迅速减小为零,找出铁磁相变的转变温度Tc大约为2.35(First of all, curriculum design idea of the Ising model used to establish a two-dimensional model, the importance of sampling and then use Monte Carlo simulation methods and their idea of ferromagnetic- paramagnetic phase transition process. Paramagnetic material calculated average energy Ev, heat capacity Cv, magnetization M and susceptibility X value, and then study Ev, Cv, M, X and temperature changes in the relationship between T and plotted into Ev-T map, Cv- T diagram, MT map, XT maps drawn paramagnetic material can be increased as the temperature increased and then stabilized value heat capacity Cv, magnetic susceptibility X as the temperature increases after the first minus small magnetization M in the transition temperature Tc decreases rapidly to zero Department to identify ferromagnetic phase transition around the transition temperature Tc for 2.35)
    2009-04-03 21:09:28下载
    积分:1
  • simulation-PV--PHOTON
    A. Mermoud, ISE, University of Geneva Note about PHOTON PV software survey Note on the sensor s calibration at three sites in Northern Germany used for PHOTON magazin s comparison of photovoltaic simulation softwares. Pierre Ineichen, ISE, University of Geneva, May 2011
    2014-12-10 22:29:56下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载