登录
首页 » matlab » Code

Code

于 2012-01-10 发布 文件大小:103KB
0 179
下载积分: 1 下载次数: 3

代码说明:

  This package is a pdf file that contains some important code related to the matlab programming. It can be of great use as code chunks iwhile developing complex matlab programs.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SimulatingtheSUIChannelModels
    Simulating the SUI Channel Models
    2007-12-27 10:28:32下载
    积分:1
  • boundary_condition_methods
    此文件包含有多种emd端点处理方法程序,其中调试过几种,效果有些可以,一些一般,有待改进,大家共同探讨.(This file contains a variety of treatment methods emd endpoint procedures, which some debugging, the effect of some can, some general, be improved, we can jointly explore.)
    2013-08-27 18:32:57下载
    积分:1
  • water
    水纹干涉图样. 可以自由设置两个波源的位置,振幅以及频率.形成水纹干涉图样并动画展示.(Waterlines interference pattern. the two wave source location, amplitude and frequency can be set freely . )
    2013-10-13 10:33:50下载
    积分:1
  • FSEDFE
    自适应均衡器设计,采用分数间隔、判决反馈结构,MMSE算法。(Adapt a FSE+DFE combination for square M-QAM over T/2-spaced microwave channels with AWGN initialized by Unbiased MMSE-FSE receiver )
    2009-05-08 16:48:24下载
    积分:1
  • S
    说明:  simnkink 用S函数实现限幅器的功能(simnkink S function with the function to achieve limiter)
    2010-06-02 17:38:59下载
    积分:1
  • system-based-on-MATLAB
    基于matlab的直接序列扩频通信系统仿真(Simulation of direct sequence spread spectrum communication system based on MATLAB)
    2013-03-31 17:16:33下载
    积分:1
  • OFDM_SLM_basic
    这个程序能够降低OFDM的PAPR,是一个初始的程序,在这个基础上可以根据需要有很多改进(Reducing the Peak-to-Average Power Ratio of Multicarrier Modulation by Selected Mapping)
    2010-12-10 17:26:56下载
    积分:1
  • imageshift-and-opticalflow
    opticalflow.m determines the velocity shift between two given images - ideally they should be virtually identical, but there is an affected translation between the two. imageshift.m creates a straightforward translation effect on an image - edges of the image wraps around to the other side
    2011-04-27 11:38:48下载
    积分:1
  • dwtg1
    MATLAB小波分析高级技术中的基于小波变换域的数字水印MATLAB源代码。(High MATLAB wavelet analysis technique based on the wavelet transform domain digital watermarking MATLAB source of generation code.)
    2007-02-09 15:33:08下载
    积分:1
  • DSPII_USTC_01
    传统的宽带信号中抑制正弦干扰的方法是采用陷波器(notch filter),为此需要精确知道干扰正弦的频率.然而当干扰正弦频率是缓慢变化时,且选频率特性要求十分尖锐时,则最好采用自适应噪声抵消的方法.下图是用一个二阶FIR的LMS自适应滤波器消除正弦干扰的一个方案。该代码实现了以下功能: 1) 借助MATLAB画出了滤波器的误差性能曲面和误差性能曲面的等值曲线; 2) 给出了最陡下降法以及LMS算法的计算公式; 3) 用MATLAB产生了方差为0.05, 均值为0白噪音S(n),并画出某次采样得到的波形; 4) 根据 2)中的公式,并利用 3)中产生的S(n),在 1)中的误差性能曲面的等值曲线上叠加画出了采用最陡下降法以及LMS法时H(n)的在叠代过程中的轨迹曲线; 5)用MATLAB计算并画出了LMS法时误差随时间n的变化曲线(对应S(n)的某一次的一次实现)和e(n)波形; 6)在 1)中的误差性能曲面的等值曲线上,叠加画出采用LMS法得到的100次实验中的H(n)的平均值的轨迹曲线; 7)最终对结果进行了分析,具体见压缩包的word文档。 (Wideband signal in the conventional sinusoidal interference suppression method is the use notch filter (notch filter), this requires precise knowledge of the frequency of a sinusoidal interference . However, when the interference frequency sinusoidal changes slowly , and the selected frequency characteristic requirements are very sharp , then best use of adaptive noise cancellation method . following figure is a second-order FIR LMS adaptive filter to eliminate a program sinusoidal interference . The code implements the following functions:   A ) draw with MATLAB error performance of the filter surface and the surface contour error performance curve 2 ) gives the steepest descent method and the LMS algorithm formula 3 ) generated using MATLAB variance of 0.05 with a mean of 0 white noise S (n), and draw a particular sampling waveform 4 ) based on 2 ) of the formula , and use 3 ) generated in S (n), in a ) the error performance curves superimposed on the surface contour pl)
    2013-11-06 13:12:36下载
    积分:1
  • 696518资源总数
  • 106148会员总数
  • 10今日下载