-
Thestatusoffuzzycontrol
说明： 文章简要介绍了模糊控制的概念和特点，并对模糊控制的原理作了说明，较详细的介绍了模糊控制的现状，包括模糊PID控制、自适应模糊控制、神经模糊控制、遗传算法优化的模糊控制、专家模糊控制等，最后对模糊控制的发展作了展望。(This paper briefly introduces the concept and characteristics of fuzzy control, and fuzzy control principle is illustrated in more detail the status of the fuzzy control including fuzzy PID control, adaptive fuzzy control, neural fuzzy control, genetic algorithm optimization of fuzzy control, expert fuzzy control, the last of the fuzzy control prospects of development.)
- 2010-04-28 21:02:30下载
- 积分：1
-
Nbem
自然边界元方法理论知识，由余德浩教授编写，介绍了自然边界法在多种偏微分方层中应用。(Natural Boundary Element Method theoretical knowledge, written by Professor Yu Dehao introduces the natural boundary method in a variety of partial differential layer.)
- 2014-10-31 16:23:35下载
- 积分：1
-
DTWMATLABsource
很好的DTW源代码，层次分明，注释详尽，很容易看懂，直接运行主程序main_speech_alignment_DTW.m 即可通过图观察DTW处理前后的波形。(DTW good source code, structured, detailed notes, it is easy to understand, can be run directly by the main program main_speech_alignment_DTW.m Figure waveform observed before and after DTW.)
- 2010-10-25 15:24:52下载
- 积分：1
-
LMS--FPGA
The simulink model of Back propagation Algorithm using an Adaptative Filter.
- 2013-07-09 15:33:19下载
- 积分：1
-
Matlab-VB
MATLAB与6-的无缝集成在
电力系统仿真中的应用
(MATLAB and 6- is seamlessly integrated into the power system simulation application)
- 2011-08-07 14:52:13下载
- 积分：1
-
jacobi
本代码是本人在做作业时所编，主要用来求解雅克比矩阵(slove jacobi matrix )
- 2009-03-10 10:04:21下载
- 积分：1
-
em1
使用最大期望算法可以在概率模型中寻找参数最大似然估计。(Using the maximum expected algorithm can seek parameters of maximum likelihood estimation in the probabilistic model)
- 2014-08-17 11:22:14下载
- 积分：1
-
Link-a-System-Level-OFDM-Simulator
针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.
To start with, go into the folder sys_link_simu, and excute the following commond from matlab:
sys_link_simu_func(a,b)
where a is the link ada)
- 2011-08-09 11:00:53下载
- 积分：1
-
11111111111116
认知无线电，退避策略，可用于学习，可运行，本人毕设研究内容(Cognitive radio, evasion strategy, can be used for learning, can be operated, I set up the research content.)
- 2019-05-13 11:18:44下载
- 积分：1
-
torque_estimation
Torque estimation of asynchronous motor by measuring voltages and current of the motor.
- 2009-07-02 18:05:58下载
- 积分：1
