-
110kv
根据设计任务书的要求，本次设计为110kV 变电站电气一次部分初步设计，并绘
制电气主接线图及其他图纸。该变电站设有两台主变压器，站内主接线分为110kV、
35kV 和10kV 三个电压等级。各个电压等级分别采用单母线分段接线、单母线分段带
旁母接线和单母线分段接线(From the guide of engineering design assignment, we have to
design primary power-system of 110kV substation and draw main
electrical one-line diagram and others. There are two main
transformer in the substation in which main electrical connection
can be divided into three voltage grades: 110kV, 35kV with 10kV.It
deposits sectionalized single bus bar scheme, sectionalized single
and transfer bus bar and sectionalized single bus bar scheme per
grade.)
- 2020-11-01 11:49:54下载
- 积分：1
-
Infrared--code
红外遥控代码，使用于51单片机。代码简单，功能强大。(Infrared remote control code, used in 51 single-chip microcomputer. The code simple, powerful.
)
- 2012-10-08 13:29:09下载
- 积分：1
-
allnew_160160_uc1698
uc1698驱动程序， 51单片机编写 ，并口和spi接口都有 ，常规字符显示都有(Uc1698 driver hhhhhhhhhhhhhhh)
- 2017-12-13 16:01:24下载
- 积分：1
-
NRF51822相关的API相关的代码
NRF51822相关的API相关的代码，不是很完整，希望有帮助(NRF51822 related API related code, not very complete, I hope to help)
- 2020-06-19 05:40:01下载
- 积分：1
-
多路舵机控制
对舵机的调试功能，通过多个舵机完成整个机器人的拼凑，进而完成机器人跳舞的任务。(The debugging function of the steering gear completes the assembly of the whole robot through multiple steering gear, and then completes the task of robot dancing.)
- 2020-06-25 18:00:01下载
- 积分：1
-
256-colorProgramming
256 色程序编写方法,非常适合初学单片机控制液晶屏的初学者学习(256-color programming method is suitable for beginners MCU LCD beginners)
- 2011-06-13 16:04:00下载
- 积分：1
-
USBXpress_API
c8051f320 usb 接口驱动程序 和上位机机通信软件及API函数。(C8051f320 usb driver and superior communication software and blast API.)
- 2010-09-03 14:43:32下载
- 积分：1
-
Maindfdsffdsaf
一个无线收发程序,使用megal8进行无线收发,定义了无线收发的协议(a wireless transceiver, the use of megal8 for wireless transceiver, a wireless transceiver defined in the agreement)
- 2006-11-01 10:57:10下载
- 积分：1
-
c-clock
脑中可以在特定的时间响起。设置闹钟定时可以响起，(Set alarm timing can ring)
- 2016-02-15 11:52:45下载
- 积分：1
-
2.程序
说明： 在此基础上，设计一种温度测量系统，能够检测温度，并通过按键调整温度的上下限值，若超过该限值，进行报警提示。该系统的硬件子电路主要用Protues仿真软件实现，具体的子电路包括：恒流源电路（TLC2543芯片）、信号放大调理电路（两线制铂电阻PT100）、单片机最小系统（AT89C51）、A/D转换电路、按键电路、显示电路、声光报警器等。该系统的软件电路以C语言为基础，在Keil中实现。最后通过软硬结合，实现电路的各种情况仿真，以此验证电路设计的正确性和合理性。(On this basis, a temperature measurement system is designed, which can detect the temperature and adjust the upper and lower limits of the temperature by pressing the key. If it exceeds the limit, an alarm will be given. The hardware sub circuit of the system is mainly realized by Proteus simulation software. The specific sub circuits include: constant current source circuit (TLC2543 chip), signal amplification and conditioning circuit (two-wire platinum resistance PT100), minimum system of single chip microcomputer (AT89C51), a / D conversion circuit, key circuit, display circuit, sound and light alarm, etc. The software circuit of the system is based on C language and implemented in keil. Finally, through the combination of hardware and software, the circuit simulation is realized to verify the correctness and rationality of the circuit design.)
- 2021-01-20 10:36:29下载
- 积分：1
