登录
首页 » MathCAD » An-Introduction-to-Programming-and-Numerical-Meth

An-Introduction-to-Programming-and-Numerical-Meth

于 2014-01-30 发布 文件大小:2008KB
0 196
下载积分: 1 下载次数: 4

代码说明:

  numerical methods analysis and the taget for the same

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Laplace_FDM
    solve laplace in3 method
    2010-10-20 11:14:51下载
    积分:1
  • multicore123
    This package realizes parallel processing on multiple coresmachines
    2010-11-18 07:07:51下载
    积分:1
  • 51622468radar_MATLAB_Code
    说明:  MATLAB中许多好用的东西,你要记下来了啊(Useful things)
    2010-05-03 14:04:03下载
    积分:1
  • dds
    采用DSP Builder设计的DDS信号发生器(The DDS signal generator using DSP BUILDER design)
    2015-04-22 15:08:41下载
    积分:1
  • question1
    最小错误率的贝叶斯分类器设计matlab代码实现(Bayes minimum error rate classifier design matlab code)
    2011-06-06 17:58:21下载
    积分:1
  • DFNN
    动态模糊神经网络,伍仕贤课本第三章源程序(Dynamic fuzzy neural network routines, the actual run-off, you can.)
    2014-09-24 21:15:53下载
    积分:1
  • ContextAwareSaliency
    Its a saliency method by sombody ok.
    2013-03-23 22:47:50下载
    积分:1
  • IMF-Intrinsic-Mode-Function-
    IMF法用作轴承故障检测程序,含所需方程m文件及图像文件(Copyright (c) 2012, Santhana Raj All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: * Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. * Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS AS IS AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIM)
    2015-01-24 21:59:50下载
    积分:1
  • gears
    基于SimMechanics的刚体系统建模gears的案例(SimMechanics modeling)
    2015-03-29 22:45:01下载
    积分:1
  • Desktop
    实现PID的三个参数的调节,使参数在一定范围内(PID three parameters to achieve the adjustment, so that parameters within a certain range)
    2017-08-08 22:09:06下载
    积分:1
  • 696518资源总数
  • 105714会员总数
  • 27今日下载