-
baseline_control
This script will setup the nonlinear simulation (UAV_NL.mdl) and call
trim and linearization routines. Select the desired aircraft here in this
script, via the "UAV_config()" function call.
- 2013-07-20 15:57:51下载
- 积分：1
-
Monte-Carlo-method
基于蒙特卡罗方法的试卷难度分布研究,Monte Carlo method based on the difficulty of distribution of papers(Monte Carlo method based on the difficulty of distribution of papers)
- 2013-09-11 08:03:26下载
- 积分：1
-
btc
block turbo codes matlab
- 2012-03-22 14:12:59下载
- 积分：1
-
AdfDemoApps
This is aadf demo page which contain some examples
- 2014-11-26 20:08:44下载
- 积分：1
-
1
说明： 齿轮箱故障诊断中振动信号是非线性、非平稳的，所以在分析振动信号之前需要对信号进行平稳化处理，该段是EMD分解的程序。(Gearbox Fault Diagnosis vibration signal is nonlinear, non-stationary, so before analyzing vibration signals the need for a smooth signal processing, the segment is the EMD program.)
- 2014-12-07 10:46:12下载
- 积分：1
-
5MatlabaPSCADfile
These codes are includes:
1- DC motor modeling using fuzzy controller
2- Wind farm modeling using DFIG in PSCAD
3- control Using LMI code
4- H bridge multilevel inverter modeling
5- induction motor control using SVPWM
- 2017-01-02 02:49:30下载
- 积分：1
-
tsls
Two-Stage Least Squares method for instrumental variables estimation
- 2011-05-13 08:06:14下载
- 积分：1
-
587754
粒子群优化算法源程序粒子群优化算法源程序粒子群优化算法源程序粒子群优化算法源程序(Source PSO PSO PSO source source source particle swarm optimization)
- 2021-02-17 15:29:46下载
- 积分：1
-
Computational-Intelligence
神经网络模型权重系数判定用的代码，back propagation(Code neural network model of weight coefficient determination, back propagation)
- 2014-12-10 07:42:20下载
- 积分：1
-
MATLAB
利用matlab 做拟合的图表 两个序列进行拟合 并画出拟合后的图和残差 另外作图的过程是每次都取相同的一段数据 且起始点不断往后推(Using matlab to do a chart to fit the proposed merger of two sequences and residual process diagram plotting another draw after fitting is always take the same piece of data and constantly pushed back the starting point)
- 2013-11-27 14:57:23下载
- 积分：1
