登录
首页 » matlab » add

add

于 2012-11-27 发布 文件大小:2KB
0 223
下载积分: 1 下载次数: 11

代码说明:

  加信噪声,经希尔伯特变换,在经过滤波器,产生单边带调幅信号(Plus letter noise, the Hilbert transform, through the filter, producing a single sideband amplitude modulation signal)

文件列表:

add.m,6872,2012-11-25

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • eg
    说明:  x=2*sin(4*pi*t)+5*cos(8*pi*t) 对其进行快速傅立叶变换 加入高斯噪声 再进行频谱分析(x = 2* sin (4* pi* t) 5* cos (8* pi* t) makes its rapid Fourier transform to re-Gaussian noise spectral analysis)
    2007-07-09 16:03:31下载
    积分:1
  • freedom3
    一个3自由度全车simulink模型,可以进行车辆动力学及相关控制的研究(3 degrees of freedom a simulink model of the entire vehicle can be related to vehicle dynamics and control research)
    2009-06-07 15:57:33下载
    积分:1
  • fx
    说明:  用matlab编的天线方向图的一个程序,能够实现均匀线阵下的方向图,还有一个music算法的实现程序(Use of matlab antenna for a procedure, can be achieved under the uniform linear array pattern, as well as the realization of a music program algorithm)
    2009-08-14 16:13:56下载
    积分:1
  • PCAxmeas_fault1
    说明:  主元分析方法(PCA)是一种基于多元统计分析的数据降维方法, 它利用过程变量间的相关关系, 建立正常工况下的主元模型, 通过检验新的数据样本相对于主元模型的背离程度, 从而发现异常和故障。 (Principal Component Analysis (PCA) is based on multivariate statistical analysis of the data reduction method, which uses the correlation between process variables and establish the normal condition of the main element model, by testing samples of the new data relative to the principal component model departure from, and thus abnormal and failure.)
    2010-04-21 21:57:27下载
    积分:1
  • montecale
    蒙特卡罗方法模拟137Cs源的662keVγ射线在NaI(Tl)闪烁体中的输运过程。开发环境:MATLAB(Monte Carlo simulation of 137Cs sources 662keVγ-ray in NaI (Tl) scintillator of the transport process. Development Environment: MATLAB)
    2007-03-12 22:05:00下载
    积分:1
  • S
    说明:  提取ERP,从matlab的数据文件中提取出脑电数据,并通过输入的信噪比进行滤波,这是第二部分 脑电数据文件(abstract ERP)
    2012-09-01 19:30:10下载
    积分:1
  • cssinger
    基于“当前”统计模型和Singer模型的机动目标跟踪的matlab程序(Matlab program for maneuvering target tracking based on "current" statistical model and Singer model)
    2021-04-11 13:38:58下载
    积分:1
  • midfilter
    MATLAB里的simulink的dspbuilder设计的图像中值滤波,可直接运行,并可通过matlab转化到quartus中并下载到FPGA运行(MATLAB simulink in the design of dspbuilder image median filtering, can be run directly, and transformed by matlab to quartus and downloaded to the FPGA run)
    2015-04-16 22:44:07下载
    积分:1
  • m_send_receive
    64长度的m序列的捕获过程,同时有数据部分经过调制解调和m序列的成帧过程等描述(64 m length sequence capture process, while there is some data through the modem and m describe the sequence of framing processes)
    2010-07-13 17:04:16下载
    积分:1
  • skindetector
    This Matlab code was developed for skin pixel detection in general imagery.
    2010-08-06 02:53:57下载
    积分:1
  • 696516资源总数
  • 106913会员总数
  • 8今日下载