-
FPGA_trainning2013A
在EDA实验课上面，自己编写的NCO程序，可以产生出比较真实的正弦波、三角波以及锯齿波，用VHDL程序编写，有modelsim仿真textbench程序(On EDA experiment, oneself write the NCO program, can produce more real sine wave, triangular wave and sawtooth wave with VHDL programming, have the modelsim simulation textbench program
)
- 2013-07-16 15:05:28下载
- 积分：1
-
Laboratory-Molecular-Biology
实验室分子生物学
Laboratory Molecular Biology(Laboratory Molecular Biology)
- 2016-12-31 19:48:31下载
- 积分：1
-
Blink_6713
宇志通信通用信号处理 开发板－GN0204中的测试EMIF的例程：利用TMS320C6713 TC2空间总线接口分别控制板上发光二极管闪烁(Ushi communication common signal processing board-GN0204 EMIF in test routines: Using TMS320C6713 TC2 space bus interface control the light-emitting diode panel flashes)
- 2015-01-22 15:59:36下载
- 积分：1
-
clarke
说明： 基于DSP28335的Clarke变换程序，包含.c与.h文件，方便直接调用。(Clarke transform program based on DSP28335, including. C and. H files, is convenient to call directly.)
- 2019-11-08 10:16:24下载
- 积分：1
-
2019.1.5电流电压双闭环的PI单相逆变器仿真
说明： 基于dsp的单相全桥逆变电路的仿真设计实用程序设计(Simulation design of single-phase full-bridge inverters based on DSP)
- 2020-06-19 06:00:01下载
- 积分：1
-
windspeedsimiulaition
采用自回归滑动模型进行风速时程的模拟，本程序主要是针对的Davenport谱(Using autoregressive moving model of the simulated wind speed time history, the program is mainly directed against the Davenport spectrum)
- 2008-12-10 12:13:04下载
- 积分：1
-
New-folder-(2)
this code will be useful in doppler effect simulation.a very useful code to say.
- 2012-11-28 14:05:25下载
- 积分：1
-
buck闭环PI控制
BUCK电路闭环实现PI控制，输入电压或负载变化时保持输出电压不变(BUCK circuit closed loop to achieve PI control, input voltage or load changes, keep the output voltage unchanged)
- 2020-07-04 16:20:02下载
- 积分：1
-
buck-boost
matlab实现BuckBoost变换器(implemention of Buckboost in matlab)
- 2012-10-15 20:50:07下载
- 积分：1
-
Carrier_AZSPWM
基于matlab的AZSPWM模型，降低共模电压(Matlab-based AZSPWM model, reduce the common mode voltage)
- 2013-09-28 02:06:48下载
- 积分：1
