登录
首页 » matlab » xwdw0

xwdw0

于 2013-12-24 发布 文件大小:3KB
0 161
下载积分: 1 下载次数: 9

代码说明:

  低轨卫星侦查确定地面目标位置,整周模糊计算(GRSS system)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • chuojuwajujishusuanfamatlab
    数据挖掘部分算法的matlab实现 C4_5 大家可以共同研究研究(Data mining algorithm matlab part we will be able to realize C4_5 Research)
    2008-03-01 13:39:37下载
    积分:1
  • zuisu
    数学模型中最速下降法matlab程序(包括算法)(The mathematical model of the steepest descent method procedures (including algorithms))
    2012-11-18 14:14:49下载
    积分:1
  • Clake-and-Jakes-channel
    文件包含Clarke和Jakes信道模型详细的理论推导与区别,并附有完整代码,可以清晰认识两种常见无线模型。(The file includes two main channel models: Clarke Model and Jakes Model. The author has deduced these two models in great detail. Simulation code is also added to the file. It is very ueeful for the beginner.)
    2021-02-24 14:29:40下载
    积分:1
  • Periodogram-powe
    说明:  平均周期图法和平滑平均周期图法估计功率谱 从经典功率谱估计周期图法原理入手,从理论上分析了其存在的局限性,借助Welch算法对其进行修正。依靠Matlab强大的数值分析和信号处理能力进行实验!! 用周期图法和welch法分别估计了一下信号的功率谱密度。采样频率200Hz,时间序列长度2048,FFT数据点数2048。其中welch法使用hanning窗,窗口长度600.(Average periodogram and periodogram smoothing method to estimate the average power spectrum from the classical power spectrum estimation periodogram principle starting from the theoretical analysis of the limitations of its existence, with the Welch algorithm, amending them. Rely on the powerful Matlab numerical analysis and signal processing capabilities to experiment!! With periodogram and welch method were estimated signal power spectral density about. Sampling frequency of 200Hz, the time sequence length 2048, FFT data points 2048. Welch method which uses hanning window, the window length of 600.)
    2011-03-16 16:45:58下载
    积分:1
  • shiyupinyutu
    对语音信号的分析,其中包括语音信号的时域波形和频域波形图。(On the speech signal analysis, including the speech signal time-domain waveform and frequency domain waveform graph. )
    2012-03-28 10:44:02下载
    积分:1
  • re1
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:51:25下载
    积分:1
  • jieguo3
    matlab 模式识别识别数据,循环处理(Matlab pattern recognition to identify data processing cycle)
    2012-06-27 16:29:14下载
    积分:1
  • Aquisition
    GPS信号跟踪与捕获,相关及非相关累积算法(GPS signal tracking and capture, accumulation-related and non related algorithms)
    2011-09-16 12:54:24下载
    积分:1
  • min_pv
    太阳能电池PV特性 基于matlab/simulink仿真(Solar PV matlab)
    2013-09-03 20:05:21下载
    积分:1
  • gpsCalculate
    包含三个M文件,其中ReadGpsData.m是读取导航文件,TimetoJD.m是将民用年历转换为儒略日,CalPos.m是将读取的数据计算卫星的坐标。 此程序计算结果较好。 (M consists of three documents, which is read ReadGpsData.m document navigation, TimetoJD.m is converted to civilian Julian calendar date, CalPos.m is to read the coordinates of the satellite data. Calculation of this procedure with satisfactory results.)
    2007-09-24 10:09:40下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载