-
matlab
用matlab编写的用中心差分法求解二自由度问题(Prepared using matlab central difference method with two degrees of freedom problem)
- 2010-08-21 10:59:42下载
- 积分：1
-
shuangzhengjiaoxinhao
完成双正交信号的数字通信系统的蒙特卡罗仿真。分析其在加性高斯白噪声下误码率与信噪比之间的关系，绘出误码率-信噪比曲线图，并和理论曲线进行比较。(Complete pairs of orthogonal signals in Monte Carlo simulation of digital communication systems. Analysis of the additive white Gaussian noise bit error rate and signal to noise ratio under the relationship between the mapped BER- signal to noise ratio curve, and and the theoretical curves for comparison.)
- 2009-12-11 19:22:48下载
- 积分：1
-
IES_2009
learning robot implementation
- 2010-01-08 11:07:27下载
- 积分：1
-
temex_tc
田纳西伊斯曼过程SIMULINK仿真模块 来自于经典文献(Tennessee Eastman process SIMULINK simulation module from the classic literature)
- 2013-09-25 21:19:56下载
- 积分：1
-
DIRECTION-OF-ARRIVAL-MEASUREMENT
DIRECTION-OF-ARRIVAL MEASUREMENT
- 2014-02-20 10:40:52下载
- 积分：1
-
MATLAB模拟卫星运动
用MATLAB仿真GPS卫星运动，仿真GPS卫星的可见性(Simulation of GPS satellite motion with MATLAB,Visibility of simulated GPS satellites)
- 2021-05-06 17:20:39下载
- 积分：1
-
fuzzy_work
模糊系统的simulink仿真，控制一阶和二阶系统(Simulink fuzzy system simulation, control first-order and second-order system)
- 2009-01-15 15:43:36下载
- 积分：1
-
prac10
here high pass is created using ideal high pass filter mask and applying FFT to the image. This will be very useful while performing filter step by step
- 2013-12-05 11:41:43下载
- 积分：1
-
8QAM
利用Matlab仿真软件，完成如图1所示的一个基本的数字通信系统。信号源产生0、1等概分布的随机信号，映射到16QAM的星座图上，同时一路信号已经被分成了实部和虚部，后边的处理建立在这两路信号的基础上。实部、虚部信号分别经过平方根升余弦滤波器，再加入高斯白噪声，然后通过匹配滤波器（平方根升余弦滤波器）。最后经过采样，判决，得到0、1信号，同原信号进行比较，给出16QAM数字系统的误码。(Using Matlab simulation software, as shown in Figure 1 to complete a basic digital communications systems. Signal source such as arise over the distribution of 0,1 random signal, is mapped to 16QAM constellation diagram, at the same time all the way the signal has been divided into real and imaginary parts, behind the deal with the establishment of these two signals in the basis. Real part, imaginary part of the signal, respectively, after a square root raised cosine filter, then add white Gaussian noise, and then through the matched filter (square root raised cosine filter). Finally, after sampling, the verdict has been 0,1 signal, to compare with the original signal is given 16QAM digital system error.)
- 2007-10-22 15:57:50下载
- 积分：1
-
correctedfinalprojectreport
desity based traffic control ..using image processing..paper presentation and knowledge bast paper.its a new idea.
- 2010-08-02 01:29:02下载
- 积分：1
