-
lab7-AD-(TIMIER)
利用28335的cpu-timer0的中断功能进行AD采集，并有AD校核程序(Use cpu-timer0 interrupt functions of 28335 AD acquisition, and checking procedures AD)
- 2013-12-12 11:44:44下载
- 积分：1
-
使用STM32控制无源蜂鸣器发声播放音乐
利用GPIO控制无源蜂鸣器发声，播放音乐。使用SysTick延时，使用位带操作寻址IO口引脚。(GPIO is used to control the voice of passive buzzer and play music. Use SysTick delay, use bit band operation to address IO pins.)
- 2020-06-17 10:20:02下载
- 积分：1
-
guangtongxinxitong
光纤通信系统是以光纤为传输媒介，光波为载波的通信系统。主要由光发送机、光纤光缆、中继器和光接收机组成，本文利用optisystem仿真光纤通信系统(Optical fiber communication system based on optical fiber transmission medium, light waves as carrier communication system.Is mainly composed of optical transmitter, optical fiber cable, repeater and optical receiver, optical fiber communication system based on optisystem simulation)
- 2016-07-19 11:24:03下载
- 积分：1
-
CAN-RS232
基于51控制的CAN 转RS232整理程序(Based on 51 control CAN turn RS232 sorting procedure)
- 2014-10-25 10:10:20下载
- 积分：1
-
MSP430-MAX31856
说明： MAX31856测试程序，MSP430F5342通过端口模拟SPI总线操作MAX31856,并将采集到的数据通过UCA1串口发送.硬件上采用隔离电源,隔离通讯接口.多路热电偶信号经多路电子开关选通后再采集.仅供参考,实验室调试通过,未投入实用.
压缩包内容:
1.MSP430程序源代码.包括测试程序及加了协议的多路采集程序.
2.硬件电路图.PDF格式,包括电路板原理图,PCB布局图,元件清单.
3.MAX31856芯片手册及官方例程.
4.PC端程序(通讯协议仿的迅威科技8通道热电偶温度变送器的协议,所以他们的PC端测试程序应该也是可用的)
整理时间:2020年4月15日(MAX31856 test procedure, MSP430F5342 simulates the SPI bus to operate the MAX31856 through the port, and converts the collected data to serial transmission through UCA1. The hardware uses isolated power supply and isolated communication interface. Reform reference, laboratory debugging passed, not occupied practical.
Compressed package content:
1. MSP430 program source code. Including test procedures and multi-channel acquisition procedures with added protocols.
2. Hardware circuit diagram. PDF format, including circuit board schematic diagram, PCB layout diagram, component list.
3. MAX31856 chip manual and official routines.
4. PC-side program (the communication protocol is a copy of the Xunwei Technology 8-channel thermocouple temperature threshold protocol, so their PC-side test program should also be available)
Arrangement time: April 15, 2020)
- 2020-04-15 12:04:45下载
- 积分：1
-
LEDTCH
说明： 这是一本关于LED技术应用研究的书籍,非常实用,相信一定能够帮到你(This is a study on the LED technology books, very practical, I believe we can help you)
- 2010-04-11 16:45:46下载
- 积分：1
-
SSD2828QN4_1.3
SSD2828数据手册1.3版本， QN封装，RGB转MIPI芯片(SSD2828 QN 1.3 version datasheet, a chip transfer RGB to MIPI)
- 2021-04-05 11:19:03下载
- 积分：1
-
pedometer
本文设计了基于加速度传感器的计步器，并通过仿真以及实际调试得到了相应的结果的记录。本实验首先通过加速度传感器检测目标物体的运动，产生脉冲，将脉冲放大后经过施密特触发器整型为方波，并给出了方波的调试电路图。然后编写程序，利用D触发器检测方波的上升沿，当上升沿到来时，计数，并对十位、个位分别编码，然后由使能信号交替控制数码管输出结果。本文给出了仿真以及调试的程序、结果。(This article is designed pedometer-based acceleration sensor and the corresponding results recorded by simulation and debugging. The experiments by first acceleration sensor detects the movement of the target object, generates a pulse, the pulse amplification is a square wave after the Schmitt trigger integer, and gives the the debug circuit diagram of a square wave. Then write procedures, the use of the rising edge of the detection of the square wave of the D flip-flop, when the rising edge, the count, and ten bits are encoded, and then alternately by the enable signal output of the digital control. In this paper, a simulation and debugging procedures, results.)
- 2013-03-13 08:58:22下载
- 积分：1
-
Temperature-display
一个单片机应用的代码，可实现基于单片机的温度数码管显示，经验证可编译通过并实现(A microcontroller application code, enabling microcontroller-based digital temperature display, proven to compile and implement)
- 2011-12-13 12:37:47下载
- 积分：1
-
M5310
中国移动物联网NB-IOT模块m5310的pcb封装，现成的，直接用(China Mobile NB module m5310 pcb package)
- 2019-01-11 16:20:25下载
- 积分：1
